01-19-2013, 07:09 PM
|
#1 |
|
Senior Member
Join Date: Mar 2012
Drives: Lightning Red BRZ MT Limited
Location: California and Philippines
Posts: 164
Thanks: 1
Thanked 33 Times in 16 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
CUSCO OIL CATCH CAN DIY
Can anyone post a DYI for the CUSCO Oil Catch Can. It would seem the Instruction Manual is incomplete.
|
|
|
|
01-19-2013, 07:19 PM
|
#2 |
|
Sarcastic SOB
Join Date: May 2012
Drives: '13 FR-S M6, '23 Volvo V60 CC
Location: Thornhill Ontario
Posts: 4,614
Thanks: 1,344
Thanked 2,844 Times in 1,635 Posts
Mentioned: 32 Post(s)
Tagged: 3 Thread(s)
|
I can't copy a link with my phone for some reason. Look up in engine and mechanical my thread asking if my install is correct.
It describes where I did my connections.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
Last edited by wbradley; 01-19-2013 at 07:51 PM. |
|
|
|
|
01-19-2013, 07:56 PM
|
#3 |
|
Senior Member
Join Date: Mar 2012
Drives: Lightning Red BRZ MT Limited
Location: California and Philippines
Posts: 164
Thanks: 1
Thanked 33 Times in 16 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Ok I'll check it later at home
|
|
|
|
|
01-19-2013, 07:58 PM
|
#4 |
|
Senior Member
Join Date: Mar 2012
Drives: Lightning Red BRZ MT Limited
Location: California and Philippines
Posts: 164
Thanks: 1
Thanked 33 Times in 16 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Found the Post but is there any picture if possible?
I would be happy for your help, Thanks |
|
|
|
|
01-19-2013, 08:18 PM
|
#5 |
|
Sarcastic SOB
Join Date: May 2012
Drives: '13 FR-S M6, '23 Volvo V60 CC
Location: Thornhill Ontario
Posts: 4,614
Thanks: 1,344
Thanked 2,844 Times in 1,635 Posts
Mentioned: 32 Post(s)
Tagged: 3 Thread(s)
|
Sorry I never took pics and my iPhone camera lens is scratched up
The PCV is on the passenger side. Look up the the DIY for installing a Radium catch can.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
|
|
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is my Cusco catch can correctly installed? | wbradley | Engine, Exhaust, Transmission | 9 | 02-24-2014 09:49 PM |
| AP Pulley - Cusco Oil Catch Can | TeamSweet86 | Engine, Exhaust, Bolt-Ons | 9 | 02-22-2013 01:25 PM |
| Password JDM w/ Cusco Catch can?? | tonytduc | Scion FR-S / Toyota 86 GT86 General Forum | 0 | 01-16-2013 11:21 PM |
| Cusco catch can install | wbradley | Engine, Exhaust, Transmission | 2 | 01-11-2013 12:11 AM |
| Cusco Oil Catch Can for BRZ/FR-S at Redline360 | Redline360 | Engine, Exhaust, Bolt-Ons | 0 | 07-01-2012 03:16 AM |
