About to start interior work (Need advice)

[ozne99]

Originally Posted by PandaSPUR

It is totally DIY-able if you have the patience. All you need is some wrap, a blow dryer (heat gun is preferred) and some sharp knives.

I bought about $20 worth of 3M matte white vinyl wrap. Here is my interior so far:







Didn't bother to take high quality pics since its not completely done yet.

Since you're painting the pieces white anyways, can I trade my silver dash pieces for your black ones? I'll cover shipping on your end and buy you a six pack.

[PandaSPUR]

Originally Posted by ozne99

Since you're painting the pieces white anyways, can I trade my silver dash pieces for your black ones? I'll cover shipping on your end and buy you a six pack.

Hm I think you have me mixed up with someone else. I have the stock silver pieces lol.

[Johnny.]

Wrapping just takes a lot of patience, but once you get the hang of it it's not too bad.
I wrapped my interior pieces in carbon fiber wrap. It was my first time, so there are a few imperfections, but no one has noticed them yet lol. It's not that expensive either, cost about $25.

[BobbyDee]

I agree, I was thinking about legit carbon but didn't have the urge to pay for that amount, hopefully one day, I get sponsored and get hooked up, for now 4D Carbon Wrap on my dash piece

[PandaSPUR]

Originally Posted by Johnny.

Wrapping just takes a lot of patience, but once you get the hang of it it's not too bad.
I wrapped my interior pieces in carbon fiber wrap. It was my first time, so there are a few imperfections, but no one has noticed them yet lol. It's not that expensive either, cost about $25.

Originally Posted by BobbyDee

I agree, I was thinking about legit carbon but didn't have the urge to pay for that amount, hopefully one day, I get sponsored and get hooked up, for now 4D Carbon Wrap on my dash piece

I personally dont like the busy look that carbon fiber adds to the interior. But damn, both of you did a good job with the wrapping.

[Aozora.BRZ]

Originally Posted by Liquid6

Bring to autobody shop to do it right

Saw your car at Moto-East a couple weeks ago. As I was reading the original post I kept trying to dig my phone for pictures of your car.

Looks good in person with the white exterior and your other mods. Don't know you keep those seats white, though.

[ozne99]

Originally Posted by PandaSPUR

Hm I think you have me mixed up with someone else. I have the stock silver pieces lol.

Your picture shows the 2015 carbon fiber pattern bezel around the radio and passenger airbag. That's what I was asking for, sorry

[PandaSPUR]

Originally Posted by ozne99

Your picture shows the 2015 carbon fiber pattern bezel around the radio and passenger airbag. That's what I was asking for, sorry

Oh that part, I see. I would trade but I'm actually not planning to wrap those pieces. Too much white for my taste if i did that lol.

[joe2628]

You could always plasti-dip the pieces..its really cheap and easy to do, plus you can always remove the dip

[Silk]

I bought the the 2015 BRZ limited which came with carbon dash but have you guys seen the White Carbon Fiber wrap that is out. It is Sharp as hell. You can look it up but you tube has a video of a guy who had his BMW wrapped and it is incredible. I worked as a graphic Artist for a sign company after Art school for 3 years and I use to wrap vehicles and parts all the time. Once you get use to it you will be putting carbon wrap over everything. If your not use to it use a lil liquid soap and water. Get a small squeegee and work center out. Not that hard !!!!