My Shift Knob. Post yours too - Page 116 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

x808drifter · 09-18-2022, 02:29 AM

Quote:

Originally Posted by Ruben_86_

uoo thanks

now i'm not sure if i want a lighter knob than stock or heavier

That's what I did after trying lighter.
My Miata was the opposite.

soundman98 · 09-18-2022, 11:31 AM

Quote:

Originally Posted by Irace86.2.0

Looks good. I like the radio and peddle dance buttons. I had a CB radio in college I exclusively used for the PA function to be a brat.

whistle while you speed?

Irace86.2.0 · 09-18-2022, 11:37 AM

Quote:

Originally Posted by soundman98

whistle while you speed?

I would scare people on the sidewalk or tell lingering drivers to move along like a cop or tell people their gas cap is open or yes, I probably whistled n holla’d.

soundman98 · 09-18-2022, 02:05 PM

i always had cb's on a shelf ready to go in all my cars. never made it there though. i'd abuse it too much!

RACECAR go brrr! · 09-18-2022, 06:55 PM

Quote:

Originally Posted by Irace86.2.0

I would scare people on the sidewalk or tell lingering drivers to move along like a cop or tell people their gas cap is open or yes, I probably whistled n holla’d.

Haha, in my old Outback, back in college, I got my hands on four PA speakers (three of them 6" in diameter, and one of them a wide 12" unit). Combined they were loud enough to be used in a small stadium. I hid them all under the car, hooked up to a dedicated AMP, which had two inputs: a microphone, and a 3.5mm jack. The microphone I used in similar vein as you, to do stuff like announce, "STEP AWAY FROM THE VEHICLE," in a very loud manner.

However, my favorite trick was to plug in my Palm Pilot, which allowed me to play all manner of sound effects. Very, VERY loud sound effects. The best one was a 2 minute long engine startup of a turbine engine, and it was absolutely hilarious to play that sound, and then start the actual engine when it was so loud nobody could hear it, and then slowly drive away while everyone was staring wondering what the hell kind of engine swap I'd fit under the hood.

Irace86.2.0 · 09-18-2022, 11:56 PM

I would broadcast music too or make fart sounds. It was pretty immature stuff.

weederr33 · 09-20-2022, 11:23 AM

I always find myself going back to the TRD knob for some reason. I really like the feel and positive engagement without it feeling soulless.

soundman98 · 09-20-2022, 08:57 PM

Quote:

Originally Posted by Irace86.2.0

I would broadcast music too or make fart sounds. It was pretty immature stuff.

i dunno, sounds like a good time to me!

weederr33 · 12-04-2022, 10:58 AM

Just found these being offered by Lathewerks and thought they looked pretty slick!

https://www.lathewerks.com/brz-oem-plus.html

Teppka · 12-07-2022, 03:05 AM

Cope · 12-09-2022, 02:37 PM

Nice!

KMA KiCKz · 12-12-2022, 03:03 PM

TRD Duracon Shift Knob

villainous_frx · 12-12-2022, 10:00 PM

Quote:

Originally Posted by KMA KiCKz

TRD Duracon Shift Knob

Super jelly of that set up. Not sure which I love more, the bezel or the knob.

MX-5RACER · 12-13-2022, 08:22 AM

I have the Voodoo knob in my BRZ and I love it. Good price, and a very high-quality finish. My Dad has one on his Miata since the '90's and loved it so much he put one on his NSX.

Here is a picture of my set-up from their website:
https://www.thompson-automotive.com/i/2013_BRZ.jpg

https://www.thompson-automotive.com/...63/9125480.htm

09-18-2022, 02:05 PM	#1614
soundman98 ProCrastinationConsultant Join Date: Sep 2013 Drives: '14 Ranger, '18 Tacoma 4Dr LB Location: chicago-ish Posts: 11,330 Thanks: 35,240 Thanked 13,673 Times in 6,781 Posts Mentioned: 98 Post(s) Tagged: 0 Thread(s)	i always had cb's on a shelf ready to go in all my cars. never made it there though. i'd abuse it too much! __________________ "The time you enjoy wasting is not wasted time"

09-18-2022, 11:56 PM	#1616
Irace86.2.0 Senior Member Join Date: Mar 2017 Drives: Q5 + BRZ + M796 Location: Santa Rosa, CA Posts: 7,883 Thanks: 5,668 Thanked 5,804 Times in 3,299 Posts Mentioned: 70 Post(s) Tagged: 0 Thread(s)	I would broadcast music too or make fart sounds. It was pretty immature stuff. __________________ My Build \| K24 Turbo Swap \| K24T BRZ SOLD

09-20-2022, 11:23 AM	#1617
weederr33 Airborne at your service Join Date: Sep 2014 Drives: '17 BRZ Series.Yellow Location: El Paso, Texas Posts: 6,325 Thanks: 4,528 Thanked 5,586 Times in 2,928 Posts Mentioned: 33 Post(s) Tagged: 2 Thread(s)	I always find myself going back to the TRD knob for some reason. I really like the feel and positive engagement without it feeling soulless. __________________ Series.Yellowbird - http://www.ft86club.com/forums/showthread.php?t=122135 MS, CSCS, TSAC-F, CPT

12-04-2022, 10:58 AM	#1619
weederr33 Airborne at your service Join Date: Sep 2014 Drives: '17 BRZ Series.Yellow Location: El Paso, Texas Posts: 6,325 Thanks: 4,528 Thanked 5,586 Times in 2,928 Posts Mentioned: 33 Post(s) Tagged: 2 Thread(s)	Just found these being offered by Lathewerks and thought they looked pretty slick! https://www.lathewerks.com/brz-oem-plus.html __________________ Series.Yellowbird - http://www.ft86club.com/forums/showthread.php?t=122135 MS, CSCS, TSAC-F, CPT

12-09-2022, 02:37 PM	#1621
Cope Driver Join Date: Dec 2014 Drives: Black 2013 BRZ Location: Somerville, MA Posts: 51 Thanks: 17 Thanked 20 Times in 17 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Nice! __________________ https://instagram.com/outrun_brz/

12-07-2022, 03:05 AM	#1620
Teppka Member Join Date: May 2021 Drives: Subaru BRZ Location: Turkey Posts: 97 Thanks: 9 Thanked 33 Times in 15 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)

12-12-2022, 03:03 PM	#1622
KMA KiCKz Certified Wumbologist Join Date: Dec 2017 Drives: 2015 Scion FR-S Location: San Jose, California Posts: 253 Thanks: 410 Thanked 328 Times in 141 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	TRD Duracon Shift Knob __________________ - My 2015 Scion FR-S OEM+ Build Thread - TRD \| Brembo \| RAYS

12-13-2022, 08:22 AM	#1624
MX-5RACER Member Join Date: Sep 2017 Drives: 1999 Miata Location: S. FL Posts: 84 Thanks: 8 Thanked 41 Times in 30 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	I have the Voodoo knob in my BRZ and I love it. Good price, and a very high-quality finish. My Dad has one on his Miata since the '90's and loved it so much he put one on his NSX. Here is a picture of my set-up from their website: https://www.thompson-automotive.com/i/2013_BRZ.jpg https://www.thompson-automotive.com/...63/9125480.htm __________________ DJ 1999 Miata VVT swap "Maggie" 2013 BRZ "Nancy-Drew BRZ"

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Shift Knob	Jwong	FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum	29	12-12-2014 01:33 AM
Kartboy Shift knob	Spartan65	Interior Parts (Incl. Lighting)	8	10-03-2012 06:18 PM
any other shift knob?	oso_25	Cosmetic Modification (Interior/Exterior/Lighting)	2	07-31-2012 01:38 AM
TRd Shift Knob	GaN-MaN	Cosmetic Modification (Interior/Exterior/Lighting)	1	07-24-2012 01:57 PM

User Name		Remember Me?
Password