follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Technical Topics > Issues | Warranty | Recalls / TSB

Issues | Warranty | Recalls / TSB Problems, issues, recalls, TSBs


User Tag List

Reply
 
Thread Tools Search this Thread
Old 08-11-2014, 05:58 PM   #1
ShadowTS
Member
 
Join Date: Aug 2014
Drives: Toyota GT86 SWP
Location: Italy
Posts: 26
Thanks: 5
Thanked 3 Times in 3 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Reliability of engine with short block replaced

Hello,

I'm a new member of FT86club and a long date fan of the FT86 project from Europe. Since the first concept car I knew I want this car, but with a limited budget I'm finally approaching used ones.
Unfortunately, there aren't many GT86 in Europe, so it's hard to find one not too far from me, with a good price, and even if you find one the price will be much higher than the magazine price suggested for a used one (because the offer is much lower than the request).

However, I have the possibility to buy one at the "right" price, but this had some issues in the past. This GT86 had a failure (i don't know the english term, I suppose you call it a "broken bushing").
Under warranty, the dealer replaced only the short block assembly (+ oil filter and gasket).

This engine failure happened almost 1 year and 10k kms ago.

Now, I want a GT86, which should be my daily driver car and should attend also 5-6 track session a year. Moreover, this car should last 6-10 years, and for sure won't stay stock (tune, exhaust for sure, maybe also ESC).

What do you think about the reliability of such half-replaced engine? I would not have that big problems if they had also replaced the cylinder head, but they didn't.

Thanks in advance.

PS: Sorry for my bad English
ShadowTS is offline   Reply With Quote
Old 08-11-2014, 06:29 PM   #2
HapaHaole
Senior Member
 
Join Date: May 2012
Drives: Grocery cart
Location: Sacramento, CA
Posts: 249
Thanks: 1
Thanked 73 Times in 52 Posts
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
Garage
IT should still carry the warranty, if in the USA. also test drive it and makes sure there are no odd noises.

I have rebuild many bottom ends on vehicles, and didnt replace the cylinder head and never had an issue.. Most problems occur a few Kilometers after being on the road.
__________________
SOLD: 2014 BRZ Limited WRB 6 Speed.
HapaHaole is offline   Reply With Quote
Old 08-11-2014, 10:16 PM   #3
zkv476
Senior Member
 
zkv476's Avatar
 
Join Date: May 2014
Drives: 2014 SWP BRZ, MT
Location: New Jersey
Posts: 240
Thanks: 11
Thanked 140 Times in 90 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
It shouldn't really be a problem if it was done properly and the cylinder head wasn't damaged prior to the short block replacement. There have been people with repeated short block replacements but they tend to have head issues or problems in other places that were never addressed leading to short block failures again.
zkv476 is offline   Reply With Quote
Old 08-21-2014, 08:19 AM   #4
ShadowTS
Member
 
Join Date: Aug 2014
Drives: Toyota GT86 SWP
Location: Italy
Posts: 26
Thanks: 5
Thanked 3 Times in 3 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
If I take the car to a Toyota Dealer/mechanic, is there any test they can do to tell me something about the reliability or the status of the engine? Cylinder compression test?
ShadowTS is offline   Reply With Quote
Old 08-22-2014, 11:49 PM   #5
regal
Senior Member
 
Join Date: Jun 2012
Drives: Scion FR-S/Toyota Yaris
Location: PA
Posts: 1,438
Thanks: 21
Thanked 316 Times in 232 Posts
Mentioned: 21 Post(s)
Tagged: 0 Thread(s)
Walk no run. Its odd to replace a short block and not the heads. Are you sure it didn't say short block bushing (aka motor mount.) ??
__________________
2013 FRS Argento Silver 6MT

Mods:
Clear fender side lights
Tactrix ZA1JB01C 2014 Calib
regal is offline   Reply With Quote
 
Reply

Tags
block, engine, failure, replacement, short

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Engine Failure (#4 Rod Bearing + Short Block) eriktherod Issues | Warranty | Recalls / TSB 215 10-30-2015 12:24 AM
WTB: FA20 Long Block/Short Block blown/running The Racers Line Engine, Exhaust, Bolt-Ons 7 07-29-2014 01:26 AM
WTB: FA20 Short Block or Blown Long Block The Racers Line Want-To-Buy Requests 1 06-29-2014 05:21 PM
Short block replaced under warranty, will my resale value drop? Yruyur Issues | Warranty | Recalls / TSB 16 02-05-2014 06:01 PM
WTB: short block or long block DOTman05 Engine, Exhaust, Bolt-Ons 2 07-14-2013 06:48 AM


All times are GMT -4. The time now is 08:18 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.