DIY Aftermarket Steering Wheel Install

[FRSEVO]

What kit did you use that included the 2 OHM resisters

[kylefrs]

Works bell short hub


Sent from my iPhone using Tapatalk

[jaime3]

Originally Posted by outlaw121

Anyone have problems putting a grip royal wheel with a works bell hub and nrg quick release on? I can't get anything to line up right do I need a adapter? Do I rotate the hub over a few teeth? If I do that the clock spring is off and abs and traction lights stay on

how did you fix the slip and abs light problem. having the same thing with the works bell hub and nrg quick release

[outlaw121]

Originally Posted by jaime3

how did you fix the slip and abs light problem. having the same thing with the works bell hub and nrg quick release

Buddy of mine at Toyota had to reset the position of the clock spring off center by a turn everything works fine

[jaime3]

Originally Posted by outlaw121

Buddy of mine at Toyota had to reset the position of the clock spring off center by a turn everything works fine

So if I go to Toyota, they will do this for me.? I thought it's illegal for dealerships/car shops to work on aftermarket steering wheels?

[outlaw121]

Originally Posted by jaime3

So if I go to Toyota, they will do this for me.? I thought it's illegal for dealerships/car shops to work on aftermarket steering wheels?

They won't do it for you we did it after work

[jaime3]

Originally Posted by outlaw121

They won't do it for you we did it after work

Do you think you can ask your friend how to know when the clockspring is properly positioned right? I've been trying to figure this out for months. I've tried different resistors, I've ask friends to help, still no fix yet

[outlaw121]

Originally Posted by jaime3

Do you think you can ask your friend how to know when the clockspring is properly positioned right? I've been trying to figure this out for months. I've tried different resistors, I've ask friends to help, still no fix yet

What kinda wheel are you running?

[jaime3]

Just an nrg. With works bell

[jaime3]

Originally Posted by outlaw121

What kinda wheel are you running?

Nrg with works bell hub

[outlaw121]

Originally Posted by jaime3

Nrg with works bell hub

Clock spring should turn 2 and a half turns each way don't try to spin it past that to hard you will snap the flat wire inside there should be a clear window on the front face of it that should show a orange gear that lets you know it's at top dead center as for the nrg hub I believe you can just set it on without having to spin it around or anything

[outlaw121]

Originally Posted by jaime3

Just an nrg. With works bell

Not using a quick release?

[jaime3]

Originally Posted by outlaw121

Not using a quick release?

Sorry, I meant to put nrg wheel and quick release with works bell hub.
So if it's centered, it needs to be 2 1/2 turns each way? I noticed there's a clear window with the orange part in there. That should be on what side once I turned it center ?

[outlaw121]

Originally Posted by jaime3

Sorry, I meant to put nrg wheel and quick release with works bell hub.

So if it's centered, it needs to be 2 1/2 turns each way? I noticed there's a clear window with the orange part in there. That should be on what side once I turned it center ?

On the left if I recall.. I believe the nrg quick release should then just bolt on and your wheel should be straight and light should go off make sure your 2 ohm resisters are both in on the air bag plugs