12-11-2015, 04:06 PM | #113 |
Senior Member
Join Date: Sep 2014
Drives: BRZ
Location: Los Angeles
Posts: 3,053
Thanks: 1,773
Thanked 2,451 Times in 1,271 Posts
Mentioned: 79 Post(s)
Tagged: 0 Thread(s)
|
is Tsudo pronounced the same as pseudo? hmmm
|
The Following User Says Thank You to swarb For This Useful Post: | bfrank1972 (12-11-2015) |
12-11-2015, 04:08 PM | #114 | |
Senior Member
Join Date: Mar 2015
Drives: 2015 Subaru BRZ Limited CWP
Location: SoCal
Posts: 1,561
Thanks: 34
Thanked 669 Times in 469 Posts
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
|
Quote:
__________________
|
|
12-11-2015, 04:09 PM | #115 | |
Senior Member
Join Date: Apr 2013
Drives: 2005 Toyota Camry
Location: 91745
Posts: 6,562
Thanks: 493
Thanked 6,093 Times in 3,029 Posts
Mentioned: 95 Post(s)
Tagged: 3 Thread(s)
|
Quote:
Just exchange it so you are not stuck with something you can't sell later... -alex |
|
The Following User Says Thank You to mav1178 For This Useful Post: | Cole (12-11-2015) |
12-11-2015, 04:19 PM | #116 | |
Senior Member
Join Date: Sep 2012
Drives: 2017 86
Location: Louisiana
Posts: 176
Thanks: 45
Thanked 50 Times in 28 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Sent from my Nexus 6P using Tapatalk |
|
The Following User Says Thank You to invaliduser For This Useful Post: | Cole (12-11-2015) |
12-11-2015, 04:27 PM | #117 |
Not a troll
Join Date: Apr 2015
Drives: FR-S
Location: Canada
Posts: 5,104
Thanks: 8,237
Thanked 5,399 Times in 2,694 Posts
Mentioned: 266 Post(s)
Tagged: 4 Thread(s)
|
I feel like it is.
On topic, bargain bin parts are always a bit of a gamble. I've lost on 2 of them. A cheap exhaust I had didn't hang evenly and my CNT header was off by about 1/16th of an inch, so I had to hammer it with a rubber mallet to get one side to slip onto the studs. |
12-11-2015, 06:44 PM | #118 |
Junior Member
Join Date: Dec 2015
Drives: 2013 Frs:Full Exhaust, NA etc
Location: Houston
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Well I disconnected the sensor from the ECU female connector that is mounted by the battery. Fully removed the sensor and its wire from the car. TBH I didn't notice it was missing the 2nd sensor hole until I pulled the factory header off. At that point I figured I could just do without the second sensor, assuming I could take care of the CEL by tuning. User preference I suppose.
|
12-11-2015, 06:55 PM | #119 |
Junior Member
Join Date: Dec 2015
Drives: 2013 Frs:Full Exhaust, NA etc
Location: Houston
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Thanks! Yeah I will check with the return policy and whatnot. I love the way the car sounds now, if I can't resolve the CEL I will try and get a replacement.
|
12-11-2015, 09:30 PM | #120 |
I love peanut butter
Join Date: Jun 2013
Drives: 2013 SWP BRZ Limited
Location: NJ
Posts: 1,598
Thanks: 428
Thanked 584 Times in 349 Posts
Mentioned: 14 Post(s)
Tagged: 2 Thread(s)
|
I'd definitely return it. I think they will fix their mistake, they responded to my inquiry quickly and even let me use a coupon code that expired.
If all else fails you could buy an o2 bung and have it welded to your header. It sucks, but if that is the only issue you have with the header then it may be an easy fix. As for the CEL, you will have it even with both o2 sensors. A tune can disable it though. |
12-11-2015, 09:43 PM | #121 |
Senior Member
Join Date: Jun 2014
Drives: frs
Location: Gunsai
Posts: 4,877
Thanks: 7,146
Thanked 2,922 Times in 1,769 Posts
Mentioned: 23 Post(s)
Tagged: 2 Thread(s)
|
|
01-09-2016, 01:27 PM | #122 | |
Senior Member
Join Date: Feb 2015
Drives: 2015 BRZ Limited
Location: Albrightsville, PA
Posts: 191
Thanks: 12
Thanked 50 Times in 38 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Quote:
__________________
2015 DGM BRZ/Gruppe-S UEL/Gruppe-S Overpipe/Invidia N1 Catback/AEM Strut/TEIN Street Basis/Cusco AOS |
|
01-14-2016, 10:57 AM | #123 |
Junior Member
Join Date: Dec 2015
Drives: 2013 Frs:Full Exhaust, NA etc
Location: Houston
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Just an update for future potential buyers. OFT stage 2 removed the CEL, so I had no reason to return the product (my preference). Virtually nothing was different with only 1 bung, aside from disconnecting the unneeded 02 sensor. As for my mounting experience, I chose to install, run it for 100 miles, then tighten up the bolts. No exhaust leaks or issues from my experience. One thing to note, installer has to use a swivel deep socket for 1 of the bolts, that resides in-between the driver side runners.
|
01-14-2016, 11:24 AM | #124 | |
Not a troll
Join Date: Apr 2015
Drives: FR-S
Location: Canada
Posts: 5,104
Thanks: 8,237
Thanked 5,399 Times in 2,694 Posts
Mentioned: 266 Post(s)
Tagged: 4 Thread(s)
|
Quote:
|
|
The Following User Says Thank You to Cole For This Useful Post: | FRSBRZGT86FAN (03-17-2016) |
01-15-2016, 09:09 PM | #125 |
I love peanut butter
Join Date: Jun 2013
Drives: 2013 SWP BRZ Limited
Location: NJ
Posts: 1,598
Thanks: 428
Thanked 584 Times in 349 Posts
Mentioned: 14 Post(s)
Tagged: 2 Thread(s)
|
In the A01C stage 2 ROM it was disabled by default. I'm surprised they would leave this enabled in any stage 2 ROM.
|
03-17-2016, 06:36 PM | #126 |
I love peanut butter
Join Date: Jun 2013
Drives: 2013 SWP BRZ Limited
Location: NJ
Posts: 1,598
Thanks: 428
Thanked 584 Times in 349 Posts
Mentioned: 14 Post(s)
Tagged: 2 Thread(s)
|
I think my header is cracked or something. I started getting like a clicky and more airy of a sound when accelerating, slightly worse gas mileage and when I pop the hood I can smell exhaust. I'm going to remove the skid plate this weekend and take a better look to confirm.
I contacted semotors.com and they said they only warranty for 1 year. I have a friend who welds who said he will attempt to fix it. Have to reflash a stage 1 OFT rom too until this is resolved. Has anyone else had issues? |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tsudo Header and Overpipe | boredom.is.me | Engine, Exhaust, Transmission | 70 | 11-04-2014 01:14 AM |
For sale: Tsudo UEL header | jupillam | Engine, Exhaust, Bolt-Ons | 10 | 07-08-2014 12:40 PM |
Anyone have the Tsudo header? | Iam-Naimless | Engine, Exhaust, Transmission | 8 | 07-02-2014 01:55 PM |
New Tsudo UEL header | Fast_Freddy | Engine, Exhaust, Transmission | 1 | 05-11-2014 01:33 AM |
Tsudo Header | ML | Engine, Exhaust, Transmission | 7 | 01-11-2014 01:31 PM |