Intec High Mount Brake + Rear Dash Cam - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

SmartedPanda · 06-03-2016, 04:48 PM

Anyone have this setup? I was curious where you put your rear camera.
Parallel and slightly off center to the Intec high mount? Or below and get alot of trunk in the view?

Thanks,

(Honestly don't know where to post this)

Brayden_23 · 06-03-2016, 04:59 PM

What if you were to wire it so the camera looks out from your trunk?? You could also try mounting it up top offset from the brake light (the OCD part of me would die with that setup, but it might work for some)

SmartedPanda · 06-04-2016, 05:45 PM

Quote:

Originally Posted by Brayden_23

What if you were to wire it so the camera looks out from your trunk?? You could also try mounting it up top offset from the brake light (the OCD part of me would die with that setup, but it might work for some)

Same about the OCD Comment.

Just wanted to see those who have High Mount 3rd + Rear dashcam, looks like I am the only one or I'm on the wrong section.

ryoma · 06-04-2016, 06:31 PM

if I ever did a rear view camera, I would ideally place it as close to the roof as possible. however, since you have a high mount brake light, it would be in the way. in that regard, placing it next to the brake light would be my next option. it does not matter if the camera is not centered since most dashcams have wide FOV's so slightly off center will not affect your picture that much.

my current front dash cam is slightly off center and you can barely tell in the videos.

this video for example: [ame="https://www.youtube.com/watch?v=IzEBJT2WFP4"]spin out - YouTube[/ame]

my dash cam is mounted about 2 inches to the right of my rear view mirror stalk. you can barely tell it is off center.

xxatsayxx · 02-10-2017, 11:21 PM

Quote:

Originally Posted by SmartedPanda

Anyone have this setup? I was curious where you put your rear camera.
Parallel and slightly off center to the Intec high mount? Or below and get alot of trunk in the view?

Thanks,

(Honestly don't know where to post this)

where did you end up mounting the rear cam? also how did you wire up your power magic pro? did you use the guide that uses the fuse box?

SmartedPanda · 02-11-2017, 02:22 PM

Quote:

Originally Posted by xxatsayxx

where did you end up mounting the rear cam? also how did you wire up your power magic pro? did you use the guide that uses the fuse box?

Hey, I just attached it below the Intec light, it only slightly blocked my view. After I tinted my car I just mounted it on the Intec itself, it's fine now. It still slightly blocks my view...

So I got rid of my 3rd brake light to get more visibility , but Intec + rear view camera is almost as bad now.

xxatsayxx · 02-11-2017, 02:37 PM

Quote:

Originally Posted by SmartedPanda

Hey, I just attached it below the Intec light, it only slightly blocked my view. After I tinted my car I just mounted it on the Intec itself, it's fine now. It still slightly blocks my view...

So I got rid of my 3rd brake light to get more visibility , but Intec + rear view camera is almost as bad now.

I see. Debating on where to put mine. How'd you wire up the power magic pro?

Sent from my iPhone using Tapatalk

SmartedPanda · 02-11-2017, 03:44 PM

Quote:

Originally Posted by xxatsayxx

I see. Debating on where to put mine. How'd you wire up the power magic pro?

Sent from my iPhone using Tapatalk

Read this 3 times, and note the fuses. That's key part. Only problem now is Blackvue software is annoying.

06-03-2016, 04:48 PM	#1
SmartedPanda Senior Member Join Date: May 2012 Drives: SWP BRZ Limited Manual. 2014 Location: San Jose, CA Posts: 647 Thanks: 155 Thanked 155 Times in 115 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Intec High Mount Brake + Rear Dash Cam Anyone have this setup? I was curious where you put your rear camera. Parallel and slightly off center to the Intec high mount? Or below and get alot of trunk in the view? Thanks, (Honestly don't know where to post this) __________________ [\| Blox 490 Knob \| Mishimoto Silicon Intake \| K&N Filter \| DD Always-On DRL \| Tomei 60S \| Weather Tech \| RED USDM TOM's Tail Lights \| OEM Underbody Panels \| Intec High Mount Brake \| RexSpeed Heated Wide Mirrors \| TC105N 17x9 \| Super Sport 245/40R17 \|TRD Quickshifter \| Porsche Brake Air Duct \| TRD Sliding Armrest\| OEM Knee Pads \| MTEC Shifter Springs\| WRX OEM Oil Cooler\| Generic PVC Catch Can\|]

06-04-2016, 06:31 PM	#4
ryoma Senior Member Join Date: Mar 2015 Drives: 2015 Subaru BRZ Limited CWP Location: SoCal Posts: 1,561 Thanks: 34 Thanked 669 Times in 469 Posts Mentioned: 13 Post(s) Tagged: 0 Thread(s)	if I ever did a rear view camera, I would ideally place it as close to the roof as possible. however, since you have a high mount brake light, it would be in the way. in that regard, placing it next to the brake light would be my next option. it does not matter if the camera is not centered since most dashcams have wide FOV's so slightly off center will not affect your picture that much. my current front dash cam is slightly off center and you can barely tell in the videos. this video for example: [ame="https://www.youtube.com/watch?v=IzEBJT2WFP4"]spin out - YouTube[/ame] my dash cam is mounted about 2 inches to the right of my rear view mirror stalk. you can barely tell it is off center. __________________ My 2015 CWP BRZ Build

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
INTEC LED High Mount Stop Lamp-featuring all OSRAM leds	pansontw	Interior Parts (Incl. Lighting)	31	06-16-2016 12:39 AM
INTEC HIGH MOUNT STOP LAMP	JPxM0Dz	Cosmetic Modification (Interior/Exterior/Lighting)	0	11-21-2014 09:31 AM
Raceseng Tow Hook w/ Go Pro Mount Built In Front/Rear Mount -fteightysix	86SPEED	Exterior Parts - The Rest	2	08-20-2013 01:37 AM

User Name		Remember Me?
Password