WHAT DID YOU DO TO YOUR FRS TODAY?

[Lorico]

TRD spoiler painted with a rattle can.

[Lorico]

The rattle can was just an experiment. I wanted to see how 15$ would be. I think the colour is so close I may just keep it the way it is.

[2much]

Originally Posted by Caspeed

Finally got my wheels and tires in.

sexy. more pics when you put them on or GTFO

[Caspeed]

Originally Posted by 2much

sexy. more pics when you put them on or GTFO

Should have more pics Sat. after I mount them...WTF???

[raven1231]

Originally Posted by ricky rod

Attachment 107423

They look nice! How much were they?

[ricky rod]

Originally Posted by raven1231

They look nice! How much were they?

Thanks, $170 front $170 rear...

[kwest.papajohns]

HID Kit from Retrofitsource.com (Highest Quality)
Retrofit coming soon!
I have done a few set for members on cobaltss.net

[G-awesome]

Originally Posted by Lorico

TRD spoiler painted with a rattle can.

Not to be nitpicky...buuuut is there a slight gap between the trunk and lip on the right side? :O

[Lorico]

Originally Posted by G-awesome

Not to be nitpicky...buuuut is there a slight gap between the trunk and lip on the right side? :O

It's not mounted yet lol. Still debating if I want to drill or use double sided tape. I'm probably going to mount it with double sided tape. And then drill and mount it with screws for rigidity. I'm sure it'll be used as a push handle in the winter if I get stuck

[zeal86]

Finished my install of my Beatrush tow hook (painted)

Installed pics...











projekt zeal86 build

[Zhangy]

reved it

[BBYZILA]

just flashed stage 1 oft tune to my frs 2013 manual. I've noticed that it pulls a little harder, but nothing extraordinary.

Maybe after it breaks in it'll feel more significant.

[Ammunition]

Originally Posted by R3NIK

BRZ Intake Design and Proving… Part 1

"The above dyno runs were just a small amount of the things we tested. The first being no filter in the stock air box. We did this along with removing all the resonators, from the intake and the results were no gains in HP. There was nothing gained at all by removing these things other than the change to the intake sound. That tells us that the stock HP and the stock intake are a good match."

It looks like they are primarily talking about the intake, and the AFR, and simply state that the stock panel filter is a good match for the car in terms of an effective AFR - since that is the primary factor of importance in their examination.

They also went on to state in the subsequent paragraph that they do believe a high-flow panel filter will make more HP over the 'dirty stock filter' at some point, which is probably also evident by the fact that Perrin sells their own drop-in filter which claims higher air flow, and more HP.

I definitely felt a small, but notable difference after I replaced my stock filter with the Apexi panel filter, but to each their own.

Getting back on topic - today I cleaned off the biggest bit of bird gunk I've seen on my car, and today marks seven weeks since I ordered my lip that is being manufactured in Japan; I'm hoping that this is the week it'll ship out, so I might be able to get it installed in another week or two.

[itsatrapp_eh]

My wife surprised me with some Tom's for for quitting smoking for a year. So yesterday I Installed some Tom's pulled the plasti dip off the roof, washed, clay bar, and waxed. Love the way they look!