|
Electronics | Audio | NAV | Infotainment Anything related to in-car electronics, navigation, and infotainment. |
|
Thread Tools | Search this Thread |
05-25-2014, 04:46 PM | #1 |
Member
Join Date: Apr 2014
Drives: 2013 FRS 6MT
Location: Decatur, GA
Posts: 63
Thanks: 5
Thanked 25 Times in 21 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Expanding foam in rear deck
I dropped a 10" JL sub and powered it with a 300w cheap amp in the trunk. Sub sounds fine and just about everything is nice and tight except for the rear deck, at high volume it constantly rattles, and on the lower notes it rattles even with the volume super low (5-15). Digging around I noticed the previous owner must have removed the rear deck like an idiot because 2 of the 4 white clips seem to be missing or broken.
Rather than pulling it apart and replacing clips, you guys think it'd be safe to just tape up all the holes and shoot some expanding foam in there to tighten everything up? I dont plan to ever remove the deck seeing as theres no speakers in it to replace, nor do i plan on getting tint, so having it be a bitch to remove isn't really an issue. The only thing I'm concerned about is any wiring that might need to be accessed in the future that would be in there. TLDR Is it safe to shoot some expanding foam under the rear deck?
__________________
2013 FR-S 6MT
|
05-25-2014, 05:13 PM | #2 |
Off Topic
Join Date: Feb 2014
Drives: 2014 Subaru BRZ Limited
Location: Vegas, baby!
Posts: 4,610
Thanks: 2,369
Thanked 4,243 Times in 2,170 Posts
Mentioned: 43 Post(s)
Tagged: 3 Thread(s)
|
I think I'd rather put some dense sponges under it, purely because you don't know if you'll ever need to remove it again. Expanding foam is a pretty permanent solution.
|
05-25-2014, 09:02 PM | #3 |
Member
Join Date: Apr 2014
Drives: 2013 FRS 6MT
Location: Decatur, GA
Posts: 63
Thanks: 5
Thanked 25 Times in 21 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
That's actually a pretty good idea and I have quite a few big sponges lying around. I may have to try that tomorrow. Thanks!
__________________
2013 FR-S 6MT
|
05-26-2014, 07:45 AM | #4 |
Senior Member
Join Date: Jul 2012
Drives: 2013 Subaru BRZ Limited in WRB
Location: Wilmington, DE
Posts: 204
Thanks: 17
Thanked 86 Times in 48 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Have you checked your third brake light? I found that it most of my rattle stemmed from this plastic third brake light. All the plastic between the light itself and the clips made it sound horrible.
__________________
|
05-27-2014, 01:04 PM | #5 |
Senior Member
Join Date: Jul 2013
Drives: 2013 RED FR-S
Location: Vegas
Posts: 103
Thanks: 23
Thanked 24 Times in 23 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
me too ! I finally had to remove it as my ALPINE 12inch Crushes it !!! Tried many tricks.Some Worked ,some didn't. Removing it worked perfectly,and 75 ft of DYNAMAT ....
|
06-15-2014, 12:54 PM | #6 | |
Member
Join Date: Apr 2014
Drives: 2013 FRS 6MT
Location: Decatur, GA
Posts: 63
Thanks: 5
Thanked 25 Times in 21 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
http://www.ft86club.com/forums/showt...33#post1797433
__________________
2013 FR-S 6MT
|
|
The Following User Says Thank You to xITSxTHExPOPEx For This Useful Post: | gramicci101 (06-15-2014) |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: REAR window top Brake Light (just top half with leds) or full rear deck | Kayzer Soze | Exterior Parts (Aero, Lighting, Etc.) | 1 | 08-31-2013 02:23 PM |
Rear deck rattle - fix it in 30s | nzer | AUSTRALIA | 0 | 07-25-2013 04:09 PM |
eliminate rear deck popping with rear strut bar? | chenshuo | Issues | Warranty | Recalls / TSB | 11 | 07-03-2013 06:44 PM |
Wtb rear deck / headliner | jshadeck | Exterior Parts (Aero, Lighting, Etc.) | 0 | 02-03-2013 08:31 PM |
do you think the rear deck rattle... | pr086 | Issues | Warranty | Recalls / TSB | 7 | 08-03-2012 04:35 PM |