PROcede ESC User Software!

[Sojhinn]

Originally Posted by j_Zer0

Does the engine need to be started, or is accessory mode enough? I have a multimeter, but how/where do I put the leads?

Remove the connection to the phantom controller. You can modify the map to read full throttle at any location of your choosing, just change the square you are in to 100 on the procede map.

Turn car on and read the procede voltage.

Read the voltage on the wire you removed from the phantom and any ground.

Sent from my iPhone using Tapatalk

[j_Zer0]

Originally Posted by Sojhinn

Remove the connection to the phantom controller. You can modify the map to read full throttle at any location of your choosing, just change the square you are in to 100 on the procede map.

Turn car on and read the procede voltage.

Read the voltage on the wire you removed from the phantom and any ground.

Sent from my iPhone using Tapatalk

My Procede puts out a max of 1.92V. Even at 100%. I guess that explains it. Is Open Flash even selling the Procedes any more? It's no longer on the products page of their website.

[Sojhinn]

Originally Posted by j_Zer0

My Procede puts out a max of 1.92V. Even at 100%. I guess that explains it. Is Open Flash even selling the Procedes any more? It's no longer on the products page of their website.

Most likely the software got screwy... try flashing a new map on it, and see what happens.


heres mine

https://drive.google.com/open?id=0B1...G43aUtZTFBNOTQ

[Sojhinn]

Originally Posted by j_Zer0

My Procede puts out a max of 1.92V. Even at 100%. I guess that explains it. Is Open Flash even selling the Procedes any more? It's no longer on the products page of their website.

Also if the map above doesnt work, PM me... I may have a solution.

[j_Zer0]

Originally Posted by Sojhinn

Also if the map above doesnt work, PM me... I may have a solution.

I think flashing your map did the trick. It's raining a bit too hard here for a proper WOT test, but I saw 4.7V and it felt like it was pulling well at around 70% throttle. I really appreciate the help man. You've straightened me out a number of times. By the way, your map is ...sporty. I like it!

[Sojhinn]

Originally Posted by j_Zer0

I think flashing your map did the trick. It's raining a bit too hard here for a proper WOT test, but I saw 4.7V and it felt like it was pulling well at around 70% throttle. I really appreciate the help man. You've straightened me out a number of times. By the way, your map is ...sporty. I like it!

Good to hear! 4.7 v should be full boost . But just make sure you don't go all the way to the right on full throttle.... But if you are happy don't mess with it... I've had issues with remapping the throttle on the procedes


Sent from my iPhone using Tapatalk

[mrjj]

Sorry for necroposting, but I just installed a Phantom and Procede and would like to know what Procede maps you guys are using. Thanks!

[Gums]

Originally Posted by mrjj

Sorry for necroposting, but I just installed a Phantom and Procede and would like to know what Procede maps you guys are using. Thanks!

Send "keen as" a private message requesting a copy of his version of a "Sojhinn" Proceed tune. It's really excellent. ESC feeds in around 2000 rpm when under load so you don't have to change down as often, and is smooth throughout the rev range. Totally transforms the car.

[mrjj]

Originally Posted by Gums

Send "keen as" a private message requesting a copy of his version of a "Sojhinn" Proceed tune. It's really excellent. ESC feeds in around 2000 rpm when under load so you don't have to change down as often, and is smooth throughout the rev range. Totally transforms the car.

Thanks!
I have been collection tunes from the forums and I have found "SOJHINNrev2" and "sojhinnrev4". Is it one of these you refer to?
I found the rev2 good. It's very similar to OFT's "Sport Throttle" tune.
However, I found the rev4 a bit to conservative. The ESC almost never went 100% at low engine revs (where it makes the most boost).

[Gums]

Originally Posted by mrjj

Thanks!
I have been collection tunes from the forums and I have found "SOJHINNrev2" and "sojhinnrev4". Is it one of these you refer to?

No, "keen as" started with one of sojhinn's proceed tunes. He went through a number of variations before finalizing. I'm sure he would be happy to send you a copy to try.

[keen as]

Originally Posted by Gums

No, "keen as" started with one of sojhinn's proceed tunes. He went through a number of variations before finalizing. I'm sure he would be happy to send you a copy to try.

Hi. This is the procede map I use. I tried to have smooth, gradual ramp of boost in the low rpm, during hard throttle application and avoid bogging the motor. I have edited it to very slightly reduce the ramp up at low revs. I only changed a few cells in the 2500 rpm row, during high throttle, from value of 80 to 70. Probably no difference. I wonder if it is better for the engine.


https://drive.google.com/file/d/0Bwi...ew?usp=sharing