![]() |
#29 | |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
![]() |
![]() |
The Following User Says Thank You to Nfsundrgrnd For This Useful Post: | Clipdat (04-06-2023) |
![]() |
#30 |
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,406
Thanks: 18,628
Thanked 16,660 Times in 7,550 Posts
Mentioned: 110 Post(s)
Tagged: 0 Thread(s)
|
No other mods, just catback right?
IAM is a bit low so it being stock tune does raise a bit of a red flag. LTFT is also high positive, but don't know engine temp and injection mode. I'd ask you to do a log then but I am drawing a blank on some parameters that we would need to see.
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
|
![]() |
![]() |
![]() |
#31 | |
Proud of BOXER
Join Date: Dec 2012
Drives: Subaru Boxer
Location: Bay Area
Posts: 8,151
Thanks: 7,083
Thanked 6,854 Times in 3,677 Posts
Mentioned: 199 Post(s)
Tagged: 0 Thread(s)
|
AEM dryflow drop in filter, Perrin silicone inlet tube, and Fujitsubo Authorise S axleback. That's it as far as power/engine performance mods.
__________________
Quote:
Last edited by Clipdat; 04-06-2023 at 07:32 PM. |
|
![]() |
![]() |
![]() |
#32 |
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,406
Thanks: 18,628
Thanked 16,660 Times in 7,550 Posts
Mentioned: 110 Post(s)
Tagged: 0 Thread(s)
|
Have you considered flashing an OTS tune to it to see if it fixes it? Just curious. The stock maf scaling is sometimes not good. I messed up scaling my maf once, went the wrong direction, and it causes all kinds of drivability issues and dropped IAM with no codes.
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
|
![]() |
![]() |
![]() |
#33 | |
Proud of BOXER
Join Date: Dec 2012
Drives: Subaru Boxer
Location: Bay Area
Posts: 8,151
Thanks: 7,083
Thanked 6,854 Times in 3,677 Posts
Mentioned: 199 Post(s)
Tagged: 0 Thread(s)
|
Yep. I was actually getting ready to flash an OTS tune, but then that stuff with the stalling/MAF sensor happened so I held off until I could ensure that the car was healthy.
__________________
Quote:
|
|
![]() |
![]() |
![]() |
#34 |
meow
Join Date: Sep 2014
Drives: a 13 e8h frs
Location: vantucky, wa
Posts: 32,309
Thanks: 52,879
Thanked 37,115 Times in 19,250 Posts
Mentioned: 1114 Post(s)
Tagged: 9 Thread(s)
|
FWIW, I believe that the knock/ping/detonation is real. I still wanted to rule out the other stuff.
__________________
|
![]() |
![]() |
![]() |
#35 | |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
![]() |
![]() |
![]() |
#36 | |
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,406
Thanks: 18,628
Thanked 16,660 Times in 7,550 Posts
Mentioned: 110 Post(s)
Tagged: 0 Thread(s)
|
Quote:
@tomm.brz this may be getting into your realm of expertise. Something you have seen before?
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
Last edited by NoHaveMSG; 04-07-2023 at 12:21 PM. |
|
![]() |
![]() |
![]() |
#37 |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
So I got a video of the knock, you can hear it loud and clear once I put the camera outside. I also logged these blips but gonna need to upload it later.
|
![]() |
![]() |
The Following User Says Thank You to Nfsundrgrnd For This Useful Post: | Clipdat (04-07-2023) |
![]() |
#38 |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
It's almost like the ecu can't trigger the direct injection fast enough when activated with the throttle blip.
|
![]() |
![]() |
![]() |
#39 |
Senior Member
Join Date: Jan 2017
Drives: brz 2017 hksv2
Location: italy
Posts: 2,235
Thanks: 506
Thanked 1,098 Times in 794 Posts
Mentioned: 67 Post(s)
Tagged: 0 Thread(s)
|
need a log of precisely that happening while recording the log to say something
also 91 oct ca nt be good enough for the stock tune and advance multiplier should drop accordigly Also if you take a look at knock correction table of stock tune you see the "worst" knocking area for Subaru is right at low rpm high load so when you jump on throttle suddenly on low rpm ![]() I d bet you have one of the first revision of the 2013-2014 tunes, which don t have a timing revisions from Subaru during fast transients/blips so timings can get too high and cause pre ignition and the most common failure caused by this is the oring in the DI injectors that disintegrates i don nt think one is able to hear the proper engine "knock" sound just by blipping the acceleator, but you can clearly hear if the oring popped, by a loud popping dry sound when you quickly blip the throttle Without a video of the sound and a log anyway is difficult to guess EDIT: oh well the OP is providing while i was writing this, so i ll wait for the logs |
![]() |
![]() |
The Following User Says Thank You to tomm.brz For This Useful Post: | Clipdat (04-07-2023) |
![]() |
#40 |
Senior Member
Join Date: Jan 2017
Drives: brz 2017 hksv2
Location: italy
Posts: 2,235
Thanks: 506
Thanked 1,098 Times in 794 Posts
Mentioned: 67 Post(s)
Tagged: 0 Thread(s)
|
from the noise, it sounds indeed like an oring popped, try to make a video with engine bay open and have someone blipping for you while you record
it gets loud when done like this so it s easier to confirm but it s already 95% popped DI oring for me You ll need to replace the oring within all 4 injectors, then flash to OTS tunes as they have the fix already, or a more recent stock tune , or a custom tune directly |
![]() |
![]() |
![]() |
#41 | |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Quote:
https://www.dropbox.com/s/k0uqa9cnq9...Knock.csv?dl=0 No knock correction which is interesting... |
|
![]() |
![]() |
![]() |
#42 | |
Member
Join Date: Feb 2021
Drives: 2013 WR blue sport tech BRZ
Location: NB
Posts: 83
Thanks: 22
Thanked 22 Times in 18 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
![]() |
![]() |
|
|
![]() |
Thread Tools | Search this Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rough idle leads to stall, runs well under load, no engine response on throttle blip | gensch | Issues | Warranty | Recalls / TSB | 8 | 09-01-2021 09:26 AM |
Abnormal noise when throttle blip or WOT shifting | evo4g63 | Issues | Warranty | Recalls / TSB | 48 | 10-16-2014 09:42 AM |
Throttle Blip Hiss | Wepeel | Issues | Warranty | Recalls / TSB | 29 | 05-31-2014 12:56 AM |
Metal Grind Sound when throttle blip | JDM-dono | Issues | Warranty | Recalls / TSB | 0 | 11-17-2013 05:37 AM |
Throttle Blip, and other features? | ashtray | BRZ First-Gen (2012+) -- General Topics | 39 | 03-07-2012 11:52 AM |