|
||||||
| Software Tuning Discuss all software tuning topics. |
 |
|
|
Thread Tools | Search this Thread |
07-15-2020, 09:22 PM
|
#1 |
|
Junior Member
Join Date: Jul 2020
Drives: 18 brz
Location: California
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
p2270 after header install
17 brz throwing a p 2270 after a header install this weekend, running OFT's stage 2+ tune. The rear 02 port did have a 90 degree adapter. Should I try replacing the sensor, removing the adapter or clearing the code to see if it comes back? Open to suggestions
|
|
|
|
07-15-2020, 11:09 PM
|
#2 |
|
SCBYD0
Join Date: Jun 2013
Drives: 18 BRZ (WRB)
Location: Dallas,TX
Posts: 544
Thanks: 1,374
Thanked 239 Times in 167 Posts
Mentioned: 7 Post(s)
Tagged: 1 Thread(s)
|
Remove the spacer and clear the code to see if it comes back. It's possible it's leaking because of it. There is no reason to run a spacer since you have a tune nor should there be a reason to replace the sensor already.
__________________
04 Scion xA > 13 FR-S stg 2 UEL E85 > 16 WRX stg 1.5 > 15 Audi S3 > 18 BRZ Limited UEL E85
|
|
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| P2270 | j_ros94 | Engine, Exhaust, Transmission | 3 | 05-21-2019 08:29 PM |
| P2270 | j_ros94 | Issues | Warranty | Recalls / TSB | 5 | 05-21-2019 06:23 PM |
| ECU Code P2270? | Razzamatazz | Issues | Warranty | Recalls / TSB | 3 | 09-10-2018 05:20 AM |
| BRZ header install | Highweigh | BRZ First-Gen (2012+) -- General Topics | 4 | 09-23-2016 10:55 AM |
| UEL Header install | Romiikr | Engine, Exhaust, Transmission | 7 | 12-21-2015 01:31 PM |
