Code p0441

[Jynx]

Originally Posted by RZNT4R

Clear them.

U0122 sometimes trips when a scantool hops on the network, P0700 is the transmission going "wtf dude there's a U0122!"

Mine doesn't do p0700 because it's manual, but half the time I connect a scan tool to mine it'll pop the U0122, even a dealership techstream made it pop. Clear and ignore.

i would say your right but when they test drive it, these codes immediately kick out so clearing it doesn't exactly work :/


Sent from my iPhone using Tapatalk

[RZNT4R]

Oh well of course, if they aren't a vestige of someone hooking up a scan tool and they come back then yes, a proper diag is in order

[Jynx]

finale update. FIXED. FINALLY. a year and half later it is gone and car feels great other than some vibration in the steering wheel.


Sent from my iPhone using Tapatalk

[Tcoat]

Originally Posted by Jynx

finale update. FIXED. FINALLY. a year and half later it is gone and car feels great other than some vibration in the steering wheel.


Sent from my iPhone using Tapatalk

And it was...?

[Jynx]

Originally Posted by Tcoat

And it was...?

so the cable going to the Purge Valve under the intake was shot. The Purge Canister above the rear diff was blowing pressure out the electrical plug so that was bad. After all that was replaced. we are good to go. the other two codes it threw was because the car battery died in idle while they were trying to fix the evap. the voltage just got too low.


Sent from my iPhone using Tapatalk