![]() |
#617 | |
PhoneFlash by EcuTeK
Join Date: Dec 2012
Drives: Edelbrock Equipped - Subaru BRZ
Location: San Diego, CA
Posts: 1,608
Thanks: 309
Thanked 1,683 Times in 581 Posts
Mentioned: 403 Post(s)
Tagged: 1 Thread(s)
|
Quote:
-Zach |
|
![]() |
![]() |
![]() |
#618 | |
Senior Member
Join Date: Dec 2015
Drives: 2015 86 GTS + Mitsi Lancer GSR
Location: Lismore AUS
Posts: 215
Thanks: 127
Thanked 93 Times in 68 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Okay review part two!!! Have been going back and forth with Zach over the last week 1 PSI at a time to make sure everything looks sweet. So far we have reached 14 PSI on 98 RON before the clutch slipped and the stock tyres wouldn't hold in 3rd. - Oops hold on, back story. I got my Sprintex 210+/SPS tuned by Delicious (yes I changed from Sprintex only because I get bored easy). After about 13 or 14 revisions from the original tune, we had it down pat. Only had to do revisions due to the SPS system being more efficient and also 98 fuel and flex fuel. OKAY BACK TO MY STORY I'm currently on the 3rd revision ONLY due to take off. I attribute this to the fact that this is an Aussie kit not sold except for here. Not ONE revision has been done due to increase PSI etc. Tune feels aaamazing, solid all the way through. Logs look gud too. And Zach even said it can keep going (but we set overboost to 15 PSI and my boost controller is set to the same). All in all, super surprised at how well the tune/car performs and can't wait until we put some E85 in and the new clutch ![]() |
|
![]() |
![]() |
The Following User Says Thank You to COO86L For This Useful Post: |
![]() |
#619 |
Junior Member
Join Date: Sep 2016
Drives: Argento FRS
Location: DMV
Posts: 8
Thanks: 0
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Ok I'm new to this tuning aspect so if I sound retarded plus forgive.
I have an ECUtek tune already on my frs. If I buy a turbo kit (I'm deciding b/w AVO and Ptuning, both supported by Delicious) would I need a new ECUtek license, dongle, and flashNgo setup? And how much would that run in total as a package? |
![]() |
![]() |
![]() |
#620 | |
Senior Member
Join Date: Jul 2014
Drives: 2014 Argento FRS
Location: 805
Posts: 262
Thanks: 67
Thanked 25 Times in 23 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Since you said you have an ECUtek tune you should already have a dongle, cable and license, you should only need a FnG tune from delicious for your corresponding turbo setup Sent from my iPhone using Tapatalk |
|
![]() |
![]() |
![]() |
#621 | |
Junior Member
Join Date: Sep 2016
Drives: Argento FRS
Location: DMV
Posts: 8
Thanks: 0
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Is the dongle installed in my frs near the ECU or OBD port with the cable? How do I get access to the license is there a registration number or Something? |
|
![]() |
![]() |
![]() |
#622 |
Senior Member
Join Date: Nov 2013
Drives: 2015 BRZ, 2005 STI
Location: San Diego, CA
Posts: 335
Thanks: 228
Thanked 225 Times in 118 Posts
Mentioned: 3 Post(s)
Tagged: 2 Thread(s)
|
Having an EcuTek tune does not necessarily mean that you own the cable and dongle, you only have a license for your ECU.
The cable and dongle retail for $350. |
![]() |
![]() |
![]() |
#623 |
Senior Member
Join Date: Jul 2015
Drives: Late 2014 Subaru BRZ
Location: Cape Coral, FL
Posts: 557
Thanks: 20
Thanked 184 Times in 139 Posts
Mentioned: 5 Post(s)
Tagged: 2 Thread(s)
|
Correct, and most tuners dont give the cables unless you request it for a price. $350
__________________
2014 Subaru BRZ
FBM Turbokit: GTX3076R - ECUTEK HRI FlexFuel tune - FBM 3" Turboback Exhaust - 550cc Injectors - Walbro 485 Fuel Pump - 4bar Map Sensor - FBM Oil Pan - ACT SB7-XTSS - AMSOIL all fluids - Forester XT Oil Cooler - Cusco engine, trans mounts - Whiteline rear differential bushings - Perrin shifter bushing - Firehawk 235/45/17 - AEM Failsafe |
![]() |
![]() |
![]() |
#624 |
PhoneFlash by EcuTeK
Join Date: Dec 2012
Drives: Edelbrock Equipped - Subaru BRZ
Location: San Diego, CA
Posts: 1,608
Thanks: 309
Thanked 1,683 Times in 581 Posts
Mentioned: 403 Post(s)
Tagged: 1 Thread(s)
|
As above, if you've been tuned then you do have an EcuTek License already. If you'd like a cable kit, it is $350. However, if you'd just like us to tune the car in person without buying a cable kit, we can do that too.
-Zach |
![]() |
![]() |
![]() |
#625 | |
Junior Member
Join Date: Sep 2016
Drives: Argento FRS
Location: DMV
Posts: 8
Thanks: 0
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Quote:
so the pricing will be ~$350 w/tax for the tune and cable kit? or is the cable kit a charge separate from the tune? |
|
![]() |
![]() |
![]() |
#626 |
driving smoother faster
Join Date: Jul 2013
Drives: Sold
Location: Some
Posts: 990
Thanks: 630
Thanked 471 Times in 286 Posts
Mentioned: 19 Post(s)
Tagged: 0 Thread(s)
|
|
![]() |
![]() |
![]() |
#628 | |
Senior Member
Join Date: Nov 2013
Drives: 2015 BRZ, 2005 STI
Location: San Diego, CA
Posts: 335
Thanks: 228
Thanked 225 Times in 118 Posts
Mentioned: 3 Post(s)
Tagged: 2 Thread(s)
|
Quote:
As @sales@delicioustuning.com pointed out, most tuners will only charge you for the tune as they can use their own EcuTek cable and dongle to flash your ECU. In my case with Delicious, I specifically asked to purchase the cable and dongle and I ended up using it the same day to get a revised tune which I was able to flash at home. |
|
![]() |
![]() |
The Following User Says Thank You to menikmati For This Useful Post: |
![]() |
#629 |
Junior Member
Join Date: Sep 2016
Drives: Argento FRS
Location: DMV
Posts: 8
Thanks: 0
Thanked 2 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
im very mechanically inclined, and my experience is based in aviation maintenance so working with ecu related issues is my pitfall. im just doing like you said and trying to save some ass pains l8r
ill be doing my build from almost scratch with all work done by me but yous guys have been super helpful |
![]() |
![]() |
The Following User Says Thank You to Sloww86 For This Useful Post: |
![]() |
#630 |
Senior Member
Join Date: Feb 2015
Drives: 2015 CWP Limited BRZ
Location: Clovis, California
Posts: 200
Thanks: 68
Thanked 46 Times in 38 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
How long does it usually take to finalize a flash and go tune for forced induction flex fuel say if you receive 1 revised map a day and send back required data logs back that same day? (Considering all things run correctly, O2 sensor is good, injectors are fine, no leaks in exhaust, etc)
__________________
addictedcollectibles.r/My IG
'86 E30 (Project) 'VARIS Widebody http://www.ft86club.com/forums/showthread.php?t=103676 |
![]() |
![]() |
|
|
![]() |
Thread Tools | Search this Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
P&L Oil Cooler for Forced Induction Applications!! Compatible with FMICs!!! | P&L Motorsports | Forced Induction | 9 | 03-26-2017 02:27 PM |
Most *fun* forced induction | bfrank1972 | Forced Induction | 45 | 12-22-2016 12:36 PM |
Infamous Performance is now offering dyno tunes by Delicious Tuning!!! | Infamous Performance | Announcements, Contests, Giveaways | 115 | 02-28-2014 01:38 PM |
February Sale. All Delicious Tuning e-tunes are 10% off!!! | Infamous Performance | Announcements, Contests, Giveaways | 19 | 02-28-2014 01:37 PM |
Infamous Performance is now offering dyno tunes by Delicious Tuning!!! | Infamous Performance | Forced Induction | 107 | 02-13-2014 12:36 PM |