Car Will Not Start After TOB Replacement

[Azzudien]

You sure you didn't do something wrong on the tranny when you did the TOB? Does the car actually go in neutral and roll when the clutch is pushed in?

[sharpsicle]

Originally Posted by LowKeySlow

Correct, I plugged in the two connectors and bolted down the ground wire. I'm still having issues. this weekend I'm going to pull the harness that connects to the starter and I'm going to continuity test each individual pin on it to find out if there's a short in the wiring.

Could you not test the starter while it's installed by bypassing the starter signal circuit and using a remote starter button? That would help you immediately localize the problem.

[LowKeySlow]

Originally Posted by Azzudien

You sure you didn't do something wrong on the tranny when you did the TOB? Does the car actually go in neutral and roll when the clutch is pushed in?

thats what i thought, car still goes into neutral tho. also we checked the transmission when we spun the crankshaft with a wrench.

[LowKeySlow]

Originally Posted by sharpsicle

Could you not test the starter while it's installed by bypassing the starter signal circuit and using a remote starter button? That would help you immediately localize the problem.

thats a really good idea! i'll try this and its super cheap!