Sonar/Spyder Tail Light Issues

[Mr.Jay]

So I have had these for a while but havent installed as I wanted to red them out. Now that they are painted I install them to find this.



My turn signals and brake lights are switched.

this is how they should work

[ame="http://www.youtube.com/watch?v=Vl22qz8tQp4"]Spyder L.E.D. Tail Lights for Scion FR-S / Subaru BRZ Demo Video - YouTube[/ame]

here are the ones I have




waiting to hear back from the site i got them from. Lots of bad luck so far with them. 1st suppose to get the lights in 2 weeks never came for a month and now this

[Accurate Race Shop]

I have a lot of experience installing spyder lights on a number of different cars. It is not uncommon for them to require you to remove wires from the plugs and rearrange them. Knowing spyder that probably wasn't in the instructions... if it even came with instructions. Also from experience you might want to put a thin bead of silicone around where the lens connects spyder lights are pretty netorius for condensation problems.

Sent from my Q10

[MemphisR]

You should have messaged me I could have told or helped you repin them

[alakim]

Are those Spyder's or Sonar's? I ordered the latter from Umnitza.com, I hope they're fine!

Cheers,
A.

[bigred18]

I just installed mine and found out the wiring was wrong. Directions were in the box (that I found later) explaining how they worked. I had yellow-to-yellow and a green-to-green wire connection. The paper explained if you were in the U.S., the wires should be yellow-to-green/yellow-to-green. If you were not U.S., it would be y-to-y and g-to-g. If your wiring is messed up, see if what I stated helps, if not I'm sorry it wasn't useful information for you.

[iiviiojica]

I had the same problem and I had them like that for months. Im happy I found this. This did fix my problem, lights are working good now. I did switch to yellow to green. Thank you for sharing