Project rebirth, FRS - STX and trackday/TTD log

[RedReplicant]

It's hard to tell in your data there, but the pressure drops I had with my car were all off throttle and immediately recovered upon picking up the throttle. Try toggling on throttle position.

Pretty much every car I've tracked before would drop pressure under this situation, I think worrying about it is mostly a case of fragile FA20 view haha

[redlined600]

Originally Posted by autoracer86

Also is that GT brake kit similar to the one CSG sells ?

Yes

Originally Posted by RedReplicant

It's hard to tell in your data there, but the pressure drops I had with my car were all off throttle and immediately recovered upon picking up the throttle. Try toggling on throttle position.

Pretty much every car I've tracked before would drop pressure under this situation, I think worrying about it is mostly a case of fragile FA20 view haha

I think you hit the nail on the head, the dip does occur as I come off throttle and transition to braking, thus the RPM drops. Even a throttle blip to rev match and it comes back up.
It's not that low, lower RPM and no load so...

[redlined600]

Went up to BIR for some Sunday fun. Overall ok, the car was obviously faster than last time I was there (by almost 3 seconds iirc) but the track didn't feel very grippy. In the afternoon was a standing start time attack. There were a bunch of ClubTR cars there to compare to. I got 3rd in my class but definitely felt I left some time on the table, especially in turn 3, for whatever reason I don't do a good job of blending the braking zone into the turn. Honestly, I think I just need to make more events and drive more.

On the last session of the day I came out of turn 3 and had what I thought was a nasty misfire which was getting worse. Not wanting to oil the track, just in case, I pulled off and got the tow of shame. Ecu showed codes for cam sensor so I had hope it was going to be something simple.

As I started to investigate I quickly started to realize it was a little more terminal

I'm pretty sure that valve is in the wrong place.


Modified low compression piston.


Right now it's hard to attribute the failure to anything. Oil Pressure looked good, Lambda looked ok, the timing is still on.
The engine was of unknown history....it could just be back luck and a valve broke.
I'll tear it down eventually to see if there are any more bread crumbs.
For now, fingers crossed that the cams and oil pump survived so I can put them on the new motor.
I had one more event planned but with upcoming travel, I think it's pretty unlikely I'll make it.