07-15-2020, 02:53 AM | #169 |
Senior Member
Join Date: Sep 2015
Drives: 2015 frs
Location: Ca
Posts: 511
Thanks: 426
Thanked 196 Times in 148 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
I was inspired to switch up my front suspension by Joel's BRZ - Low Budget Time Attack Build.
I will be using a ND Miata/ Fiat 124 front suspension setup to build a jig to build a subframe that will bolt into the frs. I will use the arms to build a jig to make adj. upper control arms. I may use the Mazda lower control arms or build new adj lowers as well. The less time I have to work on it the more time I have to rethink things. Double edged sword.
__________________
Last edited by Zer0; 07-15-2020 at 07:03 AM. |
The Following 4 Users Say Thank You to Zer0 For This Useful Post: |
07-30-2020, 06:20 AM | #170 |
Senior Member
Join Date: Sep 2015
Drives: 2015 frs
Location: Ca
Posts: 511
Thanks: 426
Thanked 196 Times in 148 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
I have received the front crossmember, and suspension. I measured it out. The mounting holes for the crossmember are slightly narrower than the frs unit. This was expected because the width of the frame rails to fit the flat 4 in the frs. The crossmember is also taller from where it attaches to the chassis to the lower control arm mounting point. If it were a closer fit I was going to prop it up under the car for some pictures. I will need to take more measurements, so I can start building jigs for the control arms, and crossmember when I get time. I dont count on it being to soon. I work to much
__________________
|
05-22-2021, 02:53 AM | #171 |
Junior Member
Join Date: Jan 2017
Drives: 2016 Subaru BRZ Series Hyper-Blue
Location: Moscow, ID
Posts: 5
Thanks: 0
Thanked 4 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Are you still working on this build friend? Was really pumped to see all the work you were doing.
|
08-06-2022, 03:57 AM | #172 |
Senior Member
Join Date: Sep 2015
Drives: 2015 frs
Location: Ca
Posts: 511
Thanks: 426
Thanked 196 Times in 148 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
|
Yep still on it when and if I get the time.
__________________
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Andy0323's Back To Basics Build Thread <Long Term Project> | andy0323 | Member's Car Journals | 15 | 02-02-2018 12:16 AM |
long term and short term | brichard0625 | Engine, Exhaust, Transmission | 7 | 08-26-2013 08:56 AM |
Long term | Bt216 | Scion FR-S / Toyota 86 GT86 General Forum | 3 | 06-06-2013 11:58 PM |
Fuel Trims - Long term and short term | victorb | Engine, Exhaust, Transmission | 6 | 03-27-2013 02:18 PM |
Short Term and Long Term Fuel Trims | naikaidriver | Engine, Exhaust, Transmission | 3 | 03-18-2013 09:55 PM |