HELP! Clutch fork retainer clips

[teamKS]

Hey everyone -

Im changing out my clutch/flywheel due to a worn throwout bearing. When I removed the trans from the engine, it was already a mess within the bell housing and the right retainer clip (if your looking into the trans housing) was already disconnected from the clutch fork.

The clips are still good, and i read somewhere on here that you can bend them back if they're not damaged - I just really need to know how that right clip is supposed to connect to the clutch fork and/or how its supposed to hold the throwout bearing.

ANY AND ALL help will be greatly appreciated. PLEASE HELP

[Apoc]

From the DIY section

http://www.ft86club.com/forums/showthread.php?t=25054

The same clips are used on several subaru models if you can't fix it.

http://parts.subaru.com/p/Subaru__BR...0539AA000.html

[teamKS]

Yeahhhh....I couldnt really tell how to properly install the right clip, but searched around on nasioc and found some pics. The right retainer clip doesnt mirror the left; they clip on oppositely.

BTW...are those clips reusable? They bent a little when the T-O bearing gave out, but I kinda formed them back with pliers. They look decent and feel strong. Thoughts....? Second clutch w/ 118,xxx miles.

Originally Posted by Apoc

From the DIY section

http://www.ft86club.com/forums/showthread.php?t=25054

The same clips are used on several subaru models if you can't fix it.

http://parts.subaru.com/p/Subaru__BR...0539AA000.html

[Apoc]

I think they are re-usable if the aren't damaged.