Issues after transmission replacement - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

f3nix.02@gmail.com · 12-21-2017, 11:27 AM

Hello everyone, this is my first post on here and I hope I can get some insight on my issues. I have a boosted 2013 FR-S that is currently tuned with ECUTEK. My transmission started to go out and since I'm still under warranty the dealer replaced it for me. After the replacement they called me because the car was in safe mode and did not rev up according to them. At first they thought somehow my tune had something to do with it so I went there and reloaded it. Everything loaded fine but I instantly tripped 6 codes: P0333, P0328, P0123, P0223, P0198 and P0193. When I try to clear them they come back on. It didn't have any CELs before going in, has anyone had this issue before?

Sent from my iPhone using Tapatalk

ermax · 12-21-2017, 11:45 AM

Man they can always fine something to blame bad work on. My guess is the the harness interconnects on the back of the engine aren’t secure. When dropping the tranny you unplug all the harnesses. You would think they could troubleshoot this on their own though.

davidsn_670 · 12-21-2017, 11:58 AM

With codes immediately coming back for sensors, sound likes they left some wires disconnected or pinched/broke the wires during removal/install. Usually "circuit high" indicates an short to power, or open in the ground circuit. They could look at those sensors data and see if they are responding at all and go from there. If all else fails, you could do a "cap" discharge. You just disconnect both battery terminals and put a jumper wire across them causing hard reset on modules. Hope this helps at all!

f3nix.02@gmail.com · 12-21-2017, 03:47 PM

Apparently there was a pin that was bent and they fixed it on one of the Harnesses. Now there's only one code (P1235)

but it runs really rough and cannot go into higher RPMs.

Sent from my iPhone using Tapatalk

chazmuska · 12-24-2017, 07:50 PM

Did you ever get this fixed? What was it? I'm about to get my trans replaced too under warranty for bad synchros...but I'm naturally aspirated.

Decep · 12-28-2017, 07:54 PM

Quote:

Originally Posted by ermax

Man they can always fine something to blame bad work on. My guess is the the harness interconnects on the back of the engine aren’t secure. When dropping the tranny you unplug all the harnesses. You would think they could troubleshoot this on their own though.

honestly amazed OP got the dealer to replace the transmission under warranty on a boosted twin.

guybo · 12-29-2017, 05:54 AM

Yeah they get the 2017 award for best dealership in the world.

bababooey · 12-29-2017, 09:53 AM

Quote:

Originally Posted by Decep

honestly amazed OP got the dealer to replace the transmission under warranty on a boosted twin.

testimonies like these is what gets people in a tizzie with stonewall's that dont wanna play ball

12-21-2017, 11:27 AM	#1
f3nix.02@gmail.com Junior Member Join Date: Feb 2016 Drives: 2013 FR-S, 2002 WS6 Trans Am Location: Chicago IL Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Issues after transmission replacement Hello everyone, this is my first post on here and I hope I can get some insight on my issues. I have a boosted 2013 FR-S that is currently tuned with ECUTEK. My transmission started to go out and since I'm still under warranty the dealer replaced it for me. After the replacement they called me because the car was in safe mode and did not rev up according to them. At first they thought somehow my tune had something to do with it so I went there and reloaded it. Everything loaded fine but I instantly tripped 6 codes: P0333, P0328, P0123, P0223, P0198 and P0193. When I try to clear them they come back on. It didn't have any CELs before going in, has anyone had this issue before? Sent from my iPhone using Tapatalk

12-21-2017, 11:45 AM	#2
ermax Senior Member Join Date: Sep 2017 Drives: 2022 BRZ Limited Silver Location: Jacksonville, FL Posts: 2,533 Thanks: 882 Thanked 2,047 Times in 1,190 Posts Mentioned: 68 Post(s) Tagged: 0 Thread(s)	Issues after transmission replacement Man they can always fine something to blame bad work on. My guess is the the harness interconnects on the back of the engine aren’t secure. When dropping the tranny you unplug all the harnesses. You would think they could troubleshoot this on their own though.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transmission Issues (AT)	RichardJ	Engine, Exhaust, Transmission	1	03-24-2017 08:47 AM
6MT Transmission Grind -> Warranty Replacement (Subaru)	Fred E	NY / NJ / CT / PA	7	11-06-2015 11:18 PM
Transmission issues	SrgtSnuggles	Engine, Exhaust, Transmission	7	09-18-2015 11:40 PM
Transmission replacement	Ludacrits	Issues \| Warranty \| Recalls / TSB	1	04-30-2014 07:02 PM
Transmission issues...	Rob_g	Issues \| Warranty \| Recalls / TSB	13	09-23-2012 07:40 PM

12-21-2017, 11:58 AM	#3
davidsn_670 Member Join Date: Oct 2015 Drives: 2015 Scion FRS Location: Tacoma, WA Posts: 44 Thanks: 23 Thanked 11 Times in 8 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	With codes immediately coming back for sensors, sound likes they left some wires disconnected or pinched/broke the wires during removal/install. Usually "circuit high" indicates an short to power, or open in the ground circuit. They could look at those sensors data and see if they are responding at all and go from there. If all else fails, you could do a "cap" discharge. You just disconnect both battery terminals and put a jumper wire across them causing hard reset on modules. Hope this helps at all!

12-21-2017, 03:47 PM	#4
f3nix.02@gmail.com Junior Member Join Date: Feb 2016 Drives: 2013 FR-S, 2002 WS6 Trans Am Location: Chicago IL Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Apparently there was a pin that was bent and they fixed it on one of the Harnesses. Now there's only one code (P1235) but it runs really rough and cannot go into higher RPMs. Sent from my iPhone using Tapatalk

12-24-2017, 07:50 PM	#5
chazmuska Member Join Date: Dec 2016 Drives: 2014 Scion FR-S Location: Arizona Posts: 80 Thanks: 19 Thanked 21 Times in 12 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Did you ever get this fixed? What was it? I'm about to get my trans replaced too under warranty for bad synchros...but I'm naturally aspirated.

12-29-2017, 05:54 AM	#7
guybo Huge E85 fan! Join Date: May 2016 Drives: 2016 Scion FRS Location: Tampa, FL, USA Posts: 1,850 Thanks: 539 Thanked 1,010 Times in 605 Posts Mentioned: 32 Post(s) Tagged: 0 Thread(s)	Yeah they get the 2017 award for best dealership in the world.

User Name		Remember Me?
Password