|
Issues | Warranty | Recalls / TSB Problems, issues, recalls, TSBs |
|
Thread Tools | Search this Thread |
09-30-2020, 07:36 PM | #1 |
Junior Member
Join Date: Sep 2020
Drives: 2013 Supercharged BRZ
Location: CA
Posts: 3
Thanks: 0
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Car doesn't want to shift into any gear when stopped
I'm new to this platform and this is the first problem I have run into. My car won't shift into any gear when it is standing still and on, but if I turn the car off it will shift into any gear with ease. To get the car to move I have to shut the car off put it into first then start it and it will run through the gears. Then it has the same problem when I come to a stop again. When I'm trying to shift into first gear with the clutch fully depressed the car drops slightly in rpm but doesn't move.
Thanks, Matt |
The Following User Says Thank You to BRZBoosted For This Useful Post: | humfrz (10-01-2020) |
09-30-2020, 07:38 PM | #2 | |
Senior Member
Join Date: May 2017
Drives: Hot lava FRS Monogram Charizard
Location: Sacramento Ca
Posts: 329
Thanks: 22
Thanked 85 Times in 63 Posts
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Sent from my IN2017 using Tapatalk |
|
09-30-2020, 07:39 PM | #3 |
Senior Member
Join Date: Oct 2015
Drives: 2017 BRZ - WRB
Location: Bay Area
Posts: 319
Thanks: 115
Thanked 208 Times in 108 Posts
Mentioned: 2 Post(s)
Tagged: 1 Thread(s)
|
Have you tried to let go of the brake slightly to let the car move a bit so that it gives the internals some slack and enables you to shift into 1st? Sometimes I do d that when it's difficult to shift into 1st when stopped, that has helped.
Sent from my SM-G973U1 using Tapatalk |
09-30-2020, 11:26 PM | #4 |
ProCrastinationConsultant
Join Date: Sep 2013
Drives: '14 Ranger, '18 Tacoma 4Dr LB
Location: chicago-ish
Posts: 11,326
Thanks: 35,214
Thanked 13,661 Times in 6,778 Posts
Mentioned: 98 Post(s)
Tagged: 0 Thread(s)
|
are you pushing the clutch all the way to the floor? sounds like the clutch isn't fully disengaging.
__________________
"The time you enjoy wasting is not wasted time"
|
10-01-2020, 04:09 AM | #5 |
Junior Member
Join Date: Sep 2020
Drives: 2013 Supercharged BRZ
Location: CA
Posts: 3
Thanks: 0
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
The car is warm and the clutch is all the way to the floor. I filled the clutch reservoir and bled the system with no results. Tomorrow I'm going to check and make sure that the trans is full.
|
10-01-2020, 05:37 AM | #6 |
Professional Mechanic
Join Date: Apr 2010
Drives: 2017 86 6MT Oceanic
Location: Quebec, Canada
Posts: 789
Thanks: 17
Thanked 633 Times in 371 Posts
Mentioned: 12 Post(s)
Tagged: 0 Thread(s)
|
Clutch not releasing completely, if it's bled properly, confirm the pedal linkage is working correctly, check for a fluid leak at the master cylinder rod under the dash, if everything checks out your issue will be in the bell housing, either a worn clutch, bad slave or damaged fork.
|
The Following 2 Users Say Thank You to RZNT4R For This Useful Post: | alphasaur (10-01-2020), soundman98 (10-01-2020) |
10-01-2020, 06:45 AM | #7 |
Senior Member
Join Date: Jul 2014
Drives: 2020 Hakone
Location: London, Ont
Posts: 69,845
Thanks: 61,656
Thanked 108,283 Times in 46,456 Posts
Mentioned: 2494 Post(s)
Tagged: 50 Thread(s)
|
Stock clutch? Flywheel?
Has the TOB been changed?
__________________
Racecar spelled backwards is Racecar, because Racecar.
|
10-01-2020, 09:20 AM | #8 |
The Dictater
Join Date: Apr 2017
Drives: '13 Red Scion FRS
Location: MD, USA
Posts: 9,386
Thanks: 26,018
Thanked 12,389 Times in 6,120 Posts
Mentioned: 85 Post(s)
Tagged: 0 Thread(s)
|
+1 sounds like a clutch issue
|
10-01-2020, 09:25 AM | #9 |
Senior Member
Join Date: Jun 2015
Drives: 2013 WRB BRZ
Location: Ohio
Posts: 672
Thanks: 258
Thanked 477 Times in 275 Posts
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
|
Have you tried slowly coming off the clutch pedal while trying to get into gear? Sometimes as I have to let it out a bit to get it to engage. It mostly happens to me when going into reverse, but I have felt it a few other times too.
__________________
|
10-01-2020, 11:07 AM | #10 |
Member
Join Date: May 2020
Drives: 2013 BRZ Limited
Location: NJ
Posts: 41
Thanks: 7
Thanked 31 Times in 15 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
If this is happening every time it is not a user error issue, some part of the system is not working correctly. Either you have a bad seal in the master or slave cylinder and fluid is getting past and therefore the clutch fork is not fully moving, or the clutch fork is bent, or there is air in the system unlikely since you said you bled it) or there is a pressure plate issue (worn spring diaphragm, bent clutch fork, etc). I would chase master/slave faults first.
__________________
2013 BRZ Limited, NASA Instructor, ex-spec miata racer
|
The Following 2 Users Say Thank You to dasting For This Useful Post: | humfrz (10-01-2020), soundman98 (10-01-2020) |
10-01-2020, 11:54 AM | #11 |
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,088
Thanks: 18,059
Thanked 16,224 Times in 7,328 Posts
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
|
Any bets on another ACT clutch? Anyone?
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
|
The Following 3 Users Say Thank You to NoHaveMSG For This Useful Post: |
10-01-2020, 12:45 PM | #12 | |
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,851
Thanks: 28,759
Thanked 31,776 Times in 16,409 Posts
Mentioned: 707 Post(s)
Tagged: 2 Thread(s)
|
Quote:
Have you tried adjusting the clutch? |
|
10-01-2020, 12:58 PM | #13 |
Senior Member
Join Date: Jul 2014
Drives: 2020 Hakone
Location: London, Ont
Posts: 69,845
Thanks: 61,656
Thanked 108,283 Times in 46,456 Posts
Mentioned: 2494 Post(s)
Tagged: 50 Thread(s)
|
This is why I asked if stock. The car is boosted so probably a safe bet the clutch is changed.
Everybody is trying to diagnose something when we don't even know what parts are in there.
__________________
Racecar spelled backwards is Racecar, because Racecar.
|
10-01-2020, 01:11 PM | #14 |
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,088
Thanks: 18,059
Thanked 16,224 Times in 7,328 Posts
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
|
After the threads that have been popping up the past few weeks, we almost need a sticky on "how to ask a question."
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
|
The Following 3 Users Say Thank You to NoHaveMSG For This Useful Post: |
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Idle (up to 3k) while stopped in gear | Eazy-V | Software Tuning | 23 | 01-24-2020 09:37 PM |
Car won't shift into first gear | Longjohnstrokems | Issues | Warranty | Recalls / TSB | 48 | 09-16-2019 06:46 PM |
Money gear shift? | accel | Scion FR-S / Toyota 86 GT86 General Forum | 56 | 04-17-2017 05:53 AM |
BRZ shift gear indicator wants you to shift gears too soon? | Jfheisenberg | BRZ First-Gen (2012+) -- General Topics | 31 | 03-24-2015 01:50 PM |
MT doesn't like 2nd gear | Nubbs | Issues | Warranty | Recalls / TSB | 18 | 08-30-2012 08:15 PM |