|
Cosmetic Modification (Interior/Exterior/Lighting) Discussions about cosmetic mods. |
|
Thread Tools | Search this Thread |
01-01-2022, 04:02 PM | #1 |
Senior Member
Join Date: May 2020
Drives: 22 BRZ limited
Location: Clarksville TN
Posts: 1,183
Thanks: 217
Thanked 990 Times in 521 Posts
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
|
2022 MT to AT center console swap
Here's how I swapped the center console out.
I ordered and used Subaru parts: Center console: 92113CC010 Lid console box: 92114CC000 Front console mat: 92177CC010 Console foam: 92166CC000 & 92166CC010 The mat for the cubby comes with the cubby so no need to order one. Start by removing the parking brake cover. Just pull it up. Remove the trim piece under the hvac controls. The top corners are the easiest to get into. Remove the 2 screws from the outer shifter trim. Pull up at the back, then remove to the rear. Remove the inner shifter trim. If removing completely, remove shift knob first. Remove the screws at the front of the console. Remove the covers from the rear console bolts. Remove the rear console bolts with a 10mm socket. Lifting at the front to separate it then go to the next step. Unplug the USB plug with the push nub where my finger is. Remove the other plug with the push nub on the center underside of the plug. Remove the center console. Remove the plugs from the USB unit. Unclip the harness from the console in 3 places. Remove the 5 screws to remove the 2 switch panels with harness attached. Remove the 9 screws from the console that hold the side trim and drink pockets. Remove the side trim pieces. They have clips attaching them, I used a screwdriver to start the separation before pulling them off. Here are some pictures of them together. MT cubby on the right. You can see that the screw tabs do not line up. Install the AT cubby into the AT console and install the side trim with 9 screws. Install the switches with harness and 5 screws. Install the USB module into the cubby and plug it in. clip in the harness. I also installed the foam in the same places that the MT console had them Installation is the reverse of removal. |
The Following 22 Users Say Thank You to dragoontwo For This Useful Post: | *Axel (01-02-2022), AK2112 (01-01-2022), bcj (01-02-2022), Blighty (02-09-2022), CincyJohn (02-07-2022), CZ6T (01-01-2022), DocWalt (01-01-2022), DustinS (01-04-2022), Interceptor777 (01-01-2022), Jdmjunkie (01-01-2022), joemysterio (01-01-2022), kevaughan (02-27-2022), Kiske (01-03-2022), McMCOO (01-02-2022), Midnightsky (01-01-2022), MMoore4545 (01-02-2022), Pete (01-01-2022), slimfit (01-01-2022), soundman98 (01-02-2022), spike021 (01-04-2022), Stonehorsw (02-07-2022), tenderization (01-01-2022) |
01-01-2022, 05:03 PM | #2 |
Senior Member
Join Date: Dec 2021
Drives: Mini
Location: Hayward
Posts: 136
Thanks: 98
Thanked 51 Times in 34 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Awesome write up! Thanks dragoontwo!
|
01-01-2022, 06:43 PM | #3 |
Senior Member
Join Date: Sep 2021
Drives: 2022 BRZ WRB
Location: Alberta
Posts: 374
Thanks: 383
Thanked 159 Times in 102 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Absolutely phenomenal write up. Thank you so much for doing this. Likely to be my very first mod, well, unless you count my CG-Lock lol.
|
01-01-2022, 11:16 PM | #4 |
Senior Member
Join Date: Sep 2021
Drives: 2022 BRZ Limited SBP
Location: Georgia
Posts: 219
Thanks: 125
Thanked 124 Times in 75 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Great write-up! I might have to do this if I cannot find a better place to put my phone. Do you find yourself using the new cup holder for your phone or a drink?
|
01-02-2022, 12:44 PM | #5 |
Junior Member
Join Date: Jan 2022
Drives: 2022 GR86 MT, 2021 Mach e GT
Location: Midwest
Posts: 2
Thanks: 0
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Nice write up.
Do you notice the increased height at all when shifting? |
01-03-2022, 12:54 PM | #6 |
Member
Join Date: Dec 2021
Drives: 2009 MX-5
Location: North Carolina
Posts: 31
Thanks: 1
Thanked 6 Times in 5 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Nice write up. Thanks for doing this. Looks like great option for my phone. What was the total cost of doing the swap?
|
01-03-2022, 04:55 PM | #7 | |
Senior Member
Join Date: May 2020
Drives: 22 BRZ limited
Location: Clarksville TN
Posts: 1,183
Thanks: 217
Thanked 990 Times in 521 Posts
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
|
Quote:
No. I do notice it resting my arm. Its a tad bit nicer with the extra little bit of height. My cost was about $35. But that's because Subaru paid for the AT console cupholder(lid console box). It has an MSRP of $256.38 + tax. You can find it cheaper at about $190 if you shop around online. |
|
02-22-2022, 08:09 PM | #8 |
Member
Join Date: Jun 2021
Drives: Future
Location: NY
Posts: 37
Thanks: 0
Thanked 25 Times in 10 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Besides a drink blocking shifting... I wonder why it just didn't come like this?
|
02-24-2022, 05:15 AM | #9 |
Senior Member
Join Date: Jul 2019
Drives: 2020 Toyota 86 GT 6M
Location: Edmonton, AB
Posts: 413
Thanks: 298
Thanked 270 Times in 137 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
agreed. unless you have a tall cup or water bottle that cupholder is far enough away from the shifter that it shouldn't be an obstruction anyways (at least for proper driving position and not the vin diesel 1 hand on 12 o clock wheel while other hand resting on shifter coolness style)
__________________
|
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Center console | orc | BRZ First-Gen (2012+) -- General Topics | 11 | 09-27-2021 11:13 AM |
New 2022 FA Swap into Old 2014 BRZ Qs? | fantasy11009 | BRZ Second-Gen (2022+) -- General Topics | 37 | 07-30-2021 09:49 AM |
My idea for a center arm rest / console cover / center cup holder | ravenblackfrs | Cosmetic Modification (Interior/Exterior/Lighting) | 67 | 02-13-2016 03:00 PM |
need help on jpm center console | Jhon19lopez | Cosmetic Modification (Interior/Exterior/Lighting) | 4 | 06-24-2013 07:57 PM |
Center Console help | mbh1101 | Cosmetic Modification (Interior/Exterior/Lighting) | 2 | 08-22-2012 09:56 AM |