|
DIY (Do-It-Yourself) Guides For all DIYs. |
|
Thread Tools | Search this Thread |
06-05-2012, 02:57 AM | #1 |
NW Region Moderator
Join Date: Mar 2010
Drives: FR-S No More
Location: Portland OR
Posts: 5,156
Thanks: 1,134
Thanked 3,186 Times in 1,091 Posts
Mentioned: 300 Post(s)
Tagged: 4 Thread(s)
|
Smoking or Redding BRZ/FR-S Tail Lights
Smoking or Redding BRZ/FR-S Tail Lights
First you need to get yourself some red lense paint or smoked lense tint. In my case, I am going to paint them red first, then put a single layer of smoke over that for a dark red look. First, pop your trunk and find the single plastic rivet on each side. A small flat-tipped screwdriver will allow you to pop the center out about 1/4". Once the center of the rivet has been popped out, you can slide the entire rivet out of the hole. Fold the carpet back to reveal the area behind the tail light. Using a small tool (like a pick, or even a nail) you can lift the plastic catch inside of the zip tie. With the catch lifted, you can pull the zip tie loose from the wiring bundle. Then unscrew the zip tie assembly from the stud and set it aside. Almost ready, just need to unplug the tail light. Push the tab in while you pull the plug out. Now you can remove the four 10mm nuts. It's easiest with a deep 10mm socket, but even with an adjustable crescent wrench it is pretty easy. Now you can pull the lamp assembly off of the car. For a good paint job, you need a clean surface. I use mineral spirits and a soft towel to wipe down every inch. I wear gloves to prevent contamination from my oily hands. I almost forgot to mask the black plastic areas that are visible when you open the trunk. Plenty of masking tape will make this paint job look professional when it gets peeled off. Now I let the lights sit for a bit to completely dry off. The key to a good paint job is cleaning, and light coats. I spray several VERY light dusting coats on the lens first. Light coats prevent fish-eyes, which are caused by contamination on the surface. If you build up a few light dusting coats then any contamination will get sealed in and won't be noticeable. I put three very light coats on, then one medium coat. To know how much paint to spray, look at a reflection of the surface while you are painting. If the coat is too light then it will still look sparkly with a texture like sand. The perfect amount is when you get just enough paint on the surface that it blends together into one continuous smooth sheen. Spray any more than that and you will start getting runs (drips). I let each coat sit for 30 minutes, so after my four coats of red I put one medium coat of lens tint over the top of it. This isn't a great photo, but after I let the lenses sit overnight they should look pretty good. No judging yet!
__________________
Last edited by DarrenDriven; 06-05-2012 at 01:18 PM. |
The Following 44 Users Say Thank You to DarrenDriven For This Useful Post: | 86 FRS (09-19-2012), aqua8701 (05-18-2013), Astroboy (07-11-2015), BabyPubes (06-27-2013), BBDGriptonia (02-09-2016), bimmerboy (06-05-2012), BlUURZ (05-13-2014), blu_ (06-05-2012), brz604 (05-11-2015), Calum (06-05-2012), cbro (06-28-2016), Chewie4299 (06-24-2012), civicdrivr (06-05-2012), Danny86 (10-12-2013), ESBjiujitsu (06-05-2012), Fly Guy (06-13-2012), FT_86_SM_GP (04-25-2015), Gaiakai (06-05-2012), Gp1666 (10-30-2012), GuerillaRacing (11-21-2012), Guff (06-05-2012), Hachiroku (06-05-2012), Jayp (06-05-2012), kurosaki (07-06-2012), Lonewolf (06-06-2012), mannie (05-07-2015), Maowc (07-12-2014), MarkRacerX (06-07-2012), Mike86CelicaGTS (03-03-2013), Mikko (10-16-2014), newports (01-03-2014), ravenblackfrs (01-03-2013), Scooby (06-05-2012), Shawnofthedead (09-25-2013), Smudgeous (06-10-2012), Snoopyalien24 (06-07-2012), Spaceywilly (06-05-2012), sticky (06-05-2012), tato.valverde (06-04-2015), touge-n00b (06-05-2012), Turbowned (06-05-2012), unvevo (03-30-2014), WRB-DZA-BRZ (06-07-2012) |
06-05-2012, 02:57 AM | #2 |
NW Region Moderator
Join Date: Mar 2010
Drives: FR-S No More
Location: Portland OR
Posts: 5,156
Thanks: 1,134
Thanked 3,186 Times in 1,091 Posts
Mentioned: 300 Post(s)
Tagged: 4 Thread(s)
|
Parking lights only Brake lights only Brake lights and hazard lights Smoked vs Stock [ame="http://www.youtube.com/watch?v=aZ9HMzTTNro"]Smoked Tail Lights on Scion FR-S - YouTube[/ame] .
__________________
Last edited by DarrenDriven; 06-05-2012 at 08:14 PM. |
The Following 11 Users Say Thank You to DarrenDriven For This Useful Post: |
06-05-2012, 03:09 AM | #3 |
Now w/ over 400 womprats!
Join Date: Nov 2011
Drives: BRZ LZR
Location: Texas/Illinois
Posts: 4,785
Thanks: 10,452
Thanked 3,420 Times in 1,424 Posts
Mentioned: 301 Post(s)
Tagged: 4 Thread(s)
|
Can't wait to see results!! The red paint looked fantastic!
__________________
"Sweet Subaru, sweet Subaru, send your BRZ unto me, for the roads of the unworthy must be baptized in speed and glory."
- The Ancient BRZ Sacrament by Zaku |
06-05-2012, 03:18 AM | #4 |
Senior Member
Join Date: Mar 2011
Drives: FRS :D
Location: Vancouver BC
Posts: 2,985
Thanks: 545
Thanked 699 Times in 438 Posts
Mentioned: 18 Post(s)
Tagged: 0 Thread(s)
|
nice! hoping you got a better shot of just red cause looking pretty good
Thanks for the DIY I plan to do this
__________________
Out of the FRS game
|
06-05-2012, 03:32 AM | #5 | |
NW Region Moderator
Join Date: Mar 2010
Drives: FR-S No More
Location: Portland OR
Posts: 5,156
Thanks: 1,134
Thanked 3,186 Times in 1,091 Posts
Mentioned: 300 Post(s)
Tagged: 4 Thread(s)
|
Quote:
Here are a couple more shots of the red before I smoked it.
__________________
|
|
The Following 4 Users Say Thank You to DarrenDriven For This Useful Post: | Byebye (10-18-2013), civicdrivr (06-05-2012), ESBjiujitsu (06-05-2012), Mike86CelicaGTS (03-03-2013) |
06-05-2012, 03:47 AM | #6 |
Sneakerhead
Join Date: Nov 2011
Drives: 2003 Honda Civic Si
Location: Dallas, TX
Posts: 327
Thanks: 16
Thanked 51 Times in 31 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
The red would've been perfect for me. The only thing about nite shade I don't like is that it isn't the right gloss I'm looking for. Nevertheless, I might try it if I can pick up an extra set once cars start getting totalled
|
06-05-2012, 04:38 AM | #7 |
Power Ranger Elite
Join Date: Nov 2011
Drives: '13 WRB Sport-tech
Location: Mississauga, Sq1
Posts: 726
Thanks: 482
Thanked 310 Times in 180 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
The smoked red looks amazing. In the last picture I'm really impressed at how glossy it turned out.
__________________
.
|
06-05-2012, 04:53 AM | #8 |
Storm Vanguard ONE
Join Date: Nov 2011
Drives: SCCA-HI CS-22 FRS
Location: Honolulu, HI
Posts: 283
Thanks: 46
Thanked 182 Times in 58 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Waiting for someone to take the plunge and do this, I quite look forward to the results!
|
06-05-2012, 06:27 AM | #9 | |
MODERATOR-SAMA
Join Date: Oct 2009
Drives: Swagtron Scooter
Location: Seattle
Posts: 2,685
Thanks: 345
Thanked 1,562 Times in 524 Posts
Mentioned: 81 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Proper tinted spray lens tinting takes about 1-2 full days without a curing room. If you do have heat on your side...drying and curing times can be cut in half.
__________________
|
|
06-05-2012, 08:15 AM | #10 |
That Guy
Join Date: Dec 2011
Drives: 2013 asphalt FRS MT
Location: Halifax, Nova Scotia
Posts: 4,865
Thanks: 5,058
Thanked 2,867 Times in 1,499 Posts
Mentioned: 82 Post(s)
Tagged: 1 Thread(s)
|
Are the reverse lights on the bottom of the bumper?
|
06-05-2012, 09:17 AM | #11 |
MUST HAVE MORE 86 ! ! !
Join Date: Apr 2012
Drives: Mazdaspeed 6 2.3 AWD Turbo
Location: Charlotte, North Carolina
Posts: 858
Thanks: 993
Thanked 232 Times in 131 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I love the solid red very awesome thanks for the post and the DIY!!!!!
__________________
WISH LIST: Whiteout FRS- Bronze 18' race rims, Cooper Zeon RS3-S tires,
Cusco Coilovers, Cusco 6 point cage, CF Lip spoiler, CF F1 Mirrors, HKS GT-86 SC 92 carmy -> 86 corolla-> Honda S2000 -> Audi TT -> Mazdaspeed6 -> NEXT UP TOYOTA FT-86!!!! |
06-05-2012, 09:20 AM | #12 |
Member
Join Date: Jun 2012
Drives: 06' 4runner
Location: Seattle, Preston, UK (3 more months)
Posts: 35
Thanks: 0
Thanked 4 Times in 2 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Red is nice! Want to see them on a car.
__________________
Current - 06' 4runner (US), 05' Mini (UK)
Past - 04' S2000 <- 07' Forester <- 05' A4 Avant <- 97' 4runner <- 05' xB <- 03' 325i <- 99' Tacoma <- 93' Integra GSR <- 93' Toy Pickup |
06-05-2012, 02:13 PM | #14 |
Senior Member
Join Date: Mar 2012
Drives: 2016 STI DGM
Location: Chattanooga, TN
Posts: 1,875
Thanks: 1,189
Thanked 1,460 Times in 662 Posts
Mentioned: 9 Post(s)
Tagged: 0 Thread(s)
|
I'd like to see how badly this prevents the lights from being visible... Looking forward to the end results!
__________________
Subaru STI :
|
|
|
Thread Tools | Search this Thread |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Are you going to smoke out your tail lights? | Liquidsnake | Cosmetic Modification (Interior/Exterior/Lighting) | 8 | 06-06-2012 10:02 AM |
HKS head and tail lamps | DIG1992 | Cosmetic Modification (Interior/Exterior/Lighting) | 5 | 05-19-2012 02:04 PM |
Tail of the Dragon | Tomcat9700 | Scion FR-S / Toyota 86 GT86 General Forum | 32 | 02-10-2012 03:30 PM |
Optional coloured tail lights? | m_life | Scion FR-S / Toyota 86 GT86 General Forum | 9 | 11-30-2011 07:20 PM |