Anyone Wire Tucks Out There? If so, let's see em!

[Ace23_BRZ]

Hey All! Just curious to see if any of you have taken on a daunting task of a wire tuck?

If so, let's see em...

I myself have taken on this project, however, I went a bit further by re-wiring my entire BRZ, both inside and out.

Either way, just wanted to see other builds, "if any."

[Wally86]

Voila: https://www.ft86club.com/forums/showthread.php?t=22680

[Ace23_BRZ]

Originally Posted by Wally86

Voila: https://www.ft86club.com/forums/showthread.php?t=22680

LoL, ahh, Chase and his blue FRS...of course something like this, I can just Google.

Was hoping for original posts of forum member's rides.

Thanks for the effort tho 🤙

[Wally86]

Originally Posted by Ace23_BRZ

LoL, ahh, Chase and his blue FRS...of course something like this, I can just Google.

Was hoping for original posts of forum member's rides.

Thanks for the effort tho 🤙

When I think of wire tucking, that car always comes to mind. It's gorgeous and incredibly well done.

[Ace23_BRZ]

Originally Posted by Wally86

When I think of wire tucking, that car always comes to mind. It's gorgeous and incredibly well done.

Agreed! This company did a great job with this build.

Hopefully, I too can inspire others with my individual build once she is revealed.

I will say though, I think I might be going a little too overboard with my wiring...I am not only doing a complete wire tuck on the exterior of the vehicle, but I am doing a nice and neat tuck in the cabin as well, including a full concentric twisted harness throughout the entire cabin as well.

Below is the start of my new interior harness, haha, and for those of you that have been following my build, "Yes," I am redoing my harness again...as I stated, if I don't feel like it's my best effort(s), I tear it apart and start over.

Haha, I think this is the one! It's just very time-consuming and requires a lot of preparation and zero room for error once complete.

Shit, wish me luck! LoL

[Wally86]

Originally Posted by Ace23_BRZ

Agreed! This company did a great job with this build.

Hopefully, I too can inspire others with my individual build once she is revealed.

I will say though, I think I might be going a little too overboard with my wiring...I am not only doing a complete wire tuck on the exterior of the vehicle, but I am doing a nice and neat tuck in the cabin as well, including a full concentric twisted harness throughout the entire cabin as well.

Below is the start of my new interior harness, haha, and for those of you that have been following my build, "Yes," I am redoing my harness again...as I stated, if I don't feel like it's my best effort(s), I tear it apart and start over.

Haha, I think this is the one! It's just very time-consuming and requires a lot of preparation and zero room for error once complete.

Shit, wish me luck! LoL

Good luck! I'll be doing the same for my new-to-me bike and upgrading the wiring gauge at the same time to help with known issues.