Phoenix Swap - Page 85 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

sdemo · 08-26-2018, 04:22 PM

Sarusanj · 09-05-2018, 08:38 PM

Spec-D exhaust with I don't remember what brand front pipe. All 2.5" piping. Some scraping on the bottom of the front pipe from being too low but it doesn't effect functionality. This gives you from the overpipe back. $240 for all.

jeffsides · 09-14-2018, 01:25 AM

.
2013 Scion FR-S. 89k Miles. 1 owner. Clean car fax. Extremely well cared for.

Proof of dyno reading 331whp. (Maha dyno) Has been dynod 360whp (cooler conditions and different brand dyno)

No test drives, serious inquires only please.

Text 480-four one four-1334

++++$17,950++++

Exterior.

Verus Engineering front splitter with race upgrade supports, dry carbon end caps., Verus Engineering non aggressive rear diffuser. And side skirts.
Rocket bunny V2 wing
Vinyl accents, hydro dipped mirror caps. . Blacked out headlight housings with added LEDs
18" TSW wheels. 245/35/16 Michelin pilot super sports tires. Toms (just spec) rear tail lights.

Interior

Full hydro dipped trim and dash panels.
A pillar gauge pod mount.

Audio.

2 12" MTX 7500 series with a MTX 1501D mono block amp, 2 farad power capacitor BeSpoke head unit.

Suspension.

KSport coil overs, voodoo13 lower control arms and toe arms

Engine

Speed By Design Turbo. Boost controller,
AEM Failsafe boost gauge, innovate oil pressure temperature guage. Moto East flex fuel kit. Exedy stage 1 clutch. Drift crash bar. Duel Radium Catch cans. Upgraded DW fuel pump and tuned using Exutek.

8lb, 10lb, & 13.5lb maps, launch control using ecutek race rom tune.

89k Miles. Boosted since 50k Miles. Turbo installed just over 3 years ago. No problems at all. Every fluid in the car it’s freshly replaced, rear differential, transmission etc. those in the Arizona community can vouch 100% for the reliability and the care taken of this car.

Sent from my iPhone using Tapatalk

jeffsides · 09-19-2018, 01:14 PM

For sale. Email Arizona86club(at)yahoo.com

Sent from my iPhone using Tapatalk

joelwastaken · 10-09-2018, 12:27 PM

Selling the OEM header from a 2015 FR-S. Has about 41k mi on it. $100 obo.

Foxbat · 11-18-2018, 12:43 AM

Sold Gold Enkei RPF 1 17x8 wrapped in 235/45ZR-17 SUMITOMO HTR Z II summers (decent amount of thread left), comes with the needed lug nuts and a set of security bolts - Sold

.Kyle · 01-01-2019, 06:18 PM

FBM Radiator

http://www.ft86club.com/forums/showthread.php?t=132183

aciddemon · 01-16-2019, 07:15 PM

Quote:

Originally Posted by aciddemon

Sadly I had to remove my CSG spec Tein SRCs. NASA introduced a penalty for TT5 class that hits these hard, as I am finishing my build, I had to switch to something else. They ride great and worked very well at the track. They have less than 2000 miles on them total and about 12 track days. New they are about 4800, asking 4000obo.

https://www.counterspacegarage.com/c...g-spec-brz-frs

I still have these, asking $2800. Can post updated pics if requested.

zussypoo · 01-17-2019, 06:41 PM

Forgot about all my parts for awhile but I need these out of my garage ASAP. Willing to take only $1200 for everything which is a steal.

Used:
K&N Air Filter - $30
Nameless frontpipe/overpipe combo - $350
Cusco strut tower braces front + rear - $240
Bubby Club racing spec coilovers - $600
Cusco tow hook - red - $80

New:
Perrin oil cooler - $560
Perrin crank pulley - $80

keithr · 03-01-2019, 02:42 PM

Selling my Jackson Racking Supercharger (C30 w/ CARB tune).

http://www.ft86club.com/forums/showthread.php?p=3191174

keithr · 03-01-2019, 02:48 PM

Torque Solution Cam Plate - $40

HLHachiRoku · 03-03-2019, 12:45 AM

These parts will fit any brz/frs or toyota 86. I have the following for sale: All parts are or best reasonable offer.

Perrin drop in filter - $30

Perrin shifter bushing - $25

Mutelki lug nuts open face short version - black - full set $60

Whiteline front camber bolt adjusters - $30

Full frs/brz clear film bra kit made by 3M- $90

High beam hid warning cancellers - so hids don’t flicker when in high beam location - $15

keithr · 03-06-2019, 01:10 AM

Anyone have a good condition OEM overpipe that you'd be willing to trade for an Invidia overpipe?

Sent from my SM-G950U using Tapatalk

FRShFA20 · 03-06-2019, 01:25 AM

Quote:

Originally Posted by keithr

Anyone have a good condition OEM overpipe that you'd be willing to trade for an Invidia overpipe?

Sent from my SM-G950U using Tapatalk

PMed

Sent from my SM-G935P using Tapatalk

11-18-2018, 12:43 AM	#1182
Foxbat Member Join Date: Jan 2015 Drives: 2015 BRZ WRB Limited M/T Location: United States Posts: 23 Thanks: 1 Thanked 18 Times in 10 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Sold Gold Enkei RPF 1 17x8 wrapped in 235/45ZR-17 SUMITOMO HTR Z II summers (decent amount of thread left), comes with the needed lug nuts and a set of security bolts - Sold Attached Images Last edited by Foxbat; 02-05-2019 at 03:40 PM. Reason: Sold

01-01-2019, 06:18 PM	#1183
.Kyle Member Join Date: May 2015 Drives: it's grey Location: Cave Creek, AZ Posts: 99 Thanks: 15 Thanked 39 Times in 23 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	FBM Radiator http://www.ft86club.com/forums/showthread.php?t=132183 __________________ hot dogs are sentient beings

01-17-2019, 06:41 PM	#1185
zussypoo Member Join Date: Oct 2014 Drives: Location: Tucson, AZ Posts: 71 Thanks: 2 Thanked 6 Times in 5 Posts Mentioned: 2 Post(s) Tagged: 1 Thread(s)	Forgot about all my parts for awhile but I need these out of my garage ASAP. Willing to take only $1200 for everything which is a steal. Used: K&N Air Filter - $30 Nameless frontpipe/overpipe combo - $350 Cusco strut tower braces front + rear - $240 Bubby Club racing spec coilovers - $600 Cusco tow hook - red - $80 New: Perrin oil cooler - $560 Perrin crank pulley - $80 __________________ 2012 Gunmetal Grey Nissan GT-R Black Edition 2016 Carbon Metallic VW Golf GTI - Sold 2014 Firestorm Scion FR-S - Sold

03-03-2019, 12:45 AM	#1188
HLHachiRoku Senior Member Join Date: Nov 2014 Drives: 2015 HL FR-S Location: AZ Posts: 130 Thanks: 34 Thanked 18 Times in 14 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	These parts will fit any brz/frs or toyota 86. I have the following for sale: All parts are or best reasonable offer. Perrin drop in filter - $30 Perrin shifter bushing - $25 Mutelki lug nuts open face short version - black - full set $60 Whiteline front camber bolt adjusters - $30 Full frs/brz clear film bra kit made by 3M- $90 High beam hid warning cancellers - so hids don’t flicker when in high beam location - $15 __________________ [\|\|•]=(86)=[•\|\|] 2015 Hot Lava FR-S (Sold) OFT → My non sensor flexfuel UEL tune Plus other mods

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pentosin Trans Fluid Swap \| Motul 300 Diff Swap \| Impressions	Dezoris	Mechanical Maintenance (Oil, Fluids, Break-In, Servicing)	15	06-06-2017 10:54 PM
Phoenix run Tue 8/26 pics	RiptorVT	Southwest	1	08-30-2014 02:45 PM
Anyone in the Phoenix area	evo4g63	Southwest	0	02-06-2013 11:19 AM
Looking to move to Phoenix from WI	FR-Shadow	Southwest	37	01-23-2013 11:38 PM

09-05-2018, 08:38 PM	#1178
Sarusanj Member Join Date: Aug 2015 Drives: 2015 FR-S Location: Chandler, AZ Posts: 11 Thanks: 0 Thanked 1 Time in 1 Post Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Spec-D exhaust with I don't remember what brand front pipe. All 2.5" piping. Some scraping on the bottom of the front pipe from being too low but it doesn't effect functionality. This gives you from the overpipe back. $240 for all.

10-09-2018, 12:27 PM	#1181
joelwastaken Member Join Date: Dec 2015 Drives: 2015 FR-S Location: Gilbert, AZ Posts: 10 Thanks: 0 Thanked 8 Times in 5 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Selling the OEM header from a 2015 FR-S. Has about 41k mi on it. $100 obo.

User Name		Remember Me?
Password