Official OpenFlash Tablet FA20 Tuning Tech Discussion Thread - Page 71 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Shiv@Openflash · 01-24-2014, 03:21 AM

Quote:

Originally Posted by steve99

I'll run a test and see, the torque logging via Bluetooth is pretty slow maybe 2 times a second so its unlikely to slow down the OFT

I don't think you will be able to run both the Torque display and the OFT logging at the same time since they operating on the same diagnostic ID in the CAN network. There is bound to be some traffic issues.

steve99 · 01-24-2014, 04:29 AM

Quote:

Originally Posted by shiv@vishnu

I don't think you will be able to run both the Torque display and the OFT logging at the same time since they operating on the same diagnostic ID in the CAN network. There is bound to be some traffic issues.

Correct, it works but is slow and unstable OFT hogs the buss suspe t due high request rate and torque runs very slow

Sniper2606 · 01-24-2014, 03:35 PM

Not sure if this has been asked before but can this Open flash device do a custom tune for vortech sc with headers overpipe etc etc?

Sniper2606 · 01-24-2014, 03:38 PM

Quote:

Originally Posted by shiv@vishnu

Pitbulls are wonderful dogs. A good friend of mine organizes a rescue effort for them. Also wonderful (and over-bred unfortunately) as German Shepards. Here's our beautiful office dog, Kenya (a rescue of course!) guarding this morning's OFT shipments.

My collection

1375967_10200793250500666_1093392706_n by sniper260687, on Flickr

164228_10200975832615979_1033680664_n by sniper260687, on Flickr

Shiv@Openflash · 01-24-2014, 03:59 PM

Quote:

Originally Posted by Sniper2606

My collection

1375967_10200793250500666_1093392706_n by sniper260687, on Flickr

164228_10200975832615979_1033680664_n by sniper260687, on Flickr

Beautiful!

2point0 · 01-24-2014, 07:52 PM

Damnit, I shoulda known! USPS.com says I have a note on the door.

I almost left work early just in case...now I'm going to have to socialize with people tonight instead of play with my new OFT.

Shiv@Openflash · 01-24-2014, 07:55 PM

Quote:

Originally Posted by 2point0

Damnit, I shoulda known! USPS.com says I have a note on the door.

I almost left work early just in case...now I'm going to have to socialize with people tonight instead of play with my new OFT.

I hate that.

Sonolin · 01-24-2014, 08:17 PM

Is there an ETA for Flex Fuel integration, or is there any plans at all on working on this?

Love the tablet & tuning solution but Flex Fuel would be needed for me after I move.

Sniper2606 · 01-24-2014, 08:40 PM

Not sure why shiv keeps ignoring my pm and note here asking about the vortech support........

FrsDuke · 01-24-2014, 09:46 PM

Quote:

Originally Posted by Sniper2606

Not sure why shiv keeps ignoring my pm and note here asking about the vortech support........

He's a busy guy
http://www.ft86club.com/forums/showp...&postcount=867
Didn't find it during my brief search but somewhere recently he said it was being pushed to feb I believe.

frslee · 01-25-2014, 12:41 AM

Quick question..

Just reflashed the ECU with stage 1 (currently have intake and cat-back).
When I was test driving, I noticed little different engine note at 4k rpm. I felt a bit of torque at that rpm. Is it normal? Right at 4k rpm, engine sounds more aggressive.

1Cor10:23 · 01-25-2014, 12:44 AM

Quote:

Originally Posted by frslee

Quick question..

Just reflashed the ECU with stage 1 (currently have intake and cat-back).
When I was test driving, I noticed little different engine note at 4k rpm. I felt a bit of torque at that rpm. Is it normal? Right at 4k rpm, engine sounds more aggressive.

That's normal - my understanding is that the vvt gets cranked up at that point to smooth out the torque dip. Had the same concern when I first flashed as well but I love the sound now

Sent from my SGH-I317M using Tapatalk

frslee · 01-25-2014, 12:48 AM

@1Cor10:23 Thanks, appreciate for the fast response.
Yeah, at first I was worried whether the tune was being really aggressive. I'm not expert in this area, so I'm going to have to trust Vishnu tuning. Now I gotta learn how to setup launch control and flat foot shifting...

solidONE · 01-25-2014, 12:51 AM

Quote:

Originally Posted by frslee

Quick question..

Just reflashed the ECU with stage 1 (currently have intake and cat-back).
When I was test driving, I noticed little different engine note at 4k rpm. I felt a bit of torque at that rpm. Is it normal? Right at 4k rpm, engine sounds more aggressive.

This is the reason you install OFT. it sound more agressive because it IS more aggressive.

After reflashing to E85 tune, I have killed 2 VQ35 equipped cars. I have AP2 S2000 in my sights next.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFlash Tablet	Rombinhood@OpenFlash	Software Tuning	1838	07-29-2023 07:35 PM
OpenFlash Tablet Stg 2 Tune (Dyno Progress)	Rombinhood@OpenFlash	Software Tuning	26	10-24-2013 02:19 PM
FBM Tuning fixed my issue, FA20 and Visconti didn't work as well	whitefrs	Forced Induction	253	08-19-2013 01:39 PM
Official MMA Thread	zigzagz94	Off-Topic Lounge [WARNING: NO POLITICS]	11	12-15-2009 11:59 PM

01-24-2014, 03:35 PM	#983
Sniper2606 Senior Member Join Date: Apr 2013 Drives: 2013 BRZ Location: OKC, OK Posts: 677 Thanks: 159 Thanked 221 Times in 138 Posts Mentioned: 6 Post(s) Tagged: 0 Thread(s)	Not sure if this has been asked before but can this Open flash device do a custom tune for vortech sc with headers overpipe etc etc?

01-24-2014, 08:17 PM	#988
Sonolin Banned Join Date: Sep 2012 Drives: 2013 Scion FR-S Location: SoCal Posts: 885 Thanks: 1,489 Thanked 289 Times in 176 Posts Mentioned: 5 Post(s) Tagged: 0 Thread(s)	Is there an ETA for Flex Fuel integration, or is there any plans at all on working on this? Love the tablet & tuning solution but Flex Fuel would be needed for me after I move.

01-24-2014, 08:40 PM	#989
Sniper2606 Senior Member Join Date: Apr 2013 Drives: 2013 BRZ Location: OKC, OK Posts: 677 Thanks: 159 Thanked 221 Times in 138 Posts Mentioned: 6 Post(s) Tagged: 0 Thread(s)	Not sure why shiv keeps ignoring my pm and note here asking about the vortech support........

01-25-2014, 12:41 AM	#991
frslee Just drive it Join Date: Mar 2013 Drives: 13' FR-S Location: Maryland Posts: 1,122 Thanks: 97 Thanked 321 Times in 218 Posts Mentioned: 10 Post(s) Tagged: 3 Thread(s)	Quick question.. Just reflashed the ECU with stage 1 (currently have intake and cat-back). When I was test driving, I noticed little different engine note at 4k rpm. I felt a bit of torque at that rpm. Is it normal? Right at 4k rpm, engine sounds more aggressive.

01-25-2014, 12:48 AM	#993
frslee Just drive it Join Date: Mar 2013 Drives: 13' FR-S Location: Maryland Posts: 1,122 Thanks: 97 Thanked 321 Times in 218 Posts Mentioned: 10 Post(s) Tagged: 3 Thread(s)	@1Cor10:23 Thanks, appreciate for the fast response. Yeah, at first I was worried whether the tune was being really aggressive. I'm not expert in this area, so I'm going to have to trust Vishnu tuning. Now I gotta learn how to setup launch control and flat foot shifting...

User Name		Remember Me?
Password