Innovate/Spritex/Bullet... What I found searching the web.

[xwd]

Ecutek has had full speed density for awhile now, but it has to be enabled and tuned by the tuner. I am not aware of any tuners doing mail order type speed density tunes.

[jflogerzi]

More work installing and more pictures

[jamesm]

Originally Posted by mad_sb

I don't expect ecutek and brzedit to be compatible. What i'm thinking is i can run around on the ecutek base map to log the tune, make a few pulls on the dyno etc.. Take the log data (ignition timing, engine load, port injection time, di injection time, etc) and build a good enough base map in brzedit to get the car running safely. At that point I would flash back the stock rom with Ecutek and flash my rom with brzedit and start fine tuning.

I'm pretty sure that ecutek's additional encryption breaks the normal pass-thru flashing that brzedit relies on. This is at least true with wrxs and such, where you have to have an ecutek vendor 'unlock' your ecu before you can pull or flash non-ecutek maps to the ecu with ecuflash.

[carbonBLUE]

Originally Posted by robispec

And dat sound...your smiles per mile increases as well...

lol smiles per mile thats all this car is! and this supercharger is going to make my face hurt for a while!

[whataboutbob]

Someday my face will be sore too. Comeon lotto ticket.

[Nikkojoe]

Can't wait to see this in person tomorrow. Hopefully everything goes smoothly

[kioton32]

Originally Posted by whataboutbob

Someday my face will be sore too. Comeon lotto ticket.

I just need it released... The anticipation is deadly...

[Accurate Race Shop]

Originally Posted by kioton32

I just need it released... The anticipation is deadly...

They are for sale in Australia according to sprintex if you really really wanted one you could have someone buy it for you and have it shipped. But the tune will not be the same and the shipping will probably be a rather large dollar amount. I'm sticking with patience on this one and waiting till innovate gets their tune fully tested and released.

Sent from my SGH-T989 using Tapatalk 2

[stockysnail]

I don't know why they don't release it without a tune for those of us that don't want one (getting one done by someone else).

[sw20kosh]

Originally Posted by jasper

I'm sticking with patience on this one and waiting till innovate gets their tune fully tested and released.

Sent from my SGH-T989 using Tapatalk 2

[JP]

can also buy the cusco version of the kit now: http://www.ebay.com.au/itm/CUSCO-SPR...item3a819faded

[Panman]

Originally Posted by JP

can also buy the cusco version of the kit now: http://www.ebay.com.au/itm/CUSCO-SPR...item3a819faded

Using the figures quoted there (and Metric HP) 79Hp Gain - 142->221HP at the treads. Specifically states "Not for sale to US"

[Fast_Freddy]

Originally Posted by Panman

Using the figures quoted there (and Metric HP) 79Hp Gain - 142->221HP at the treads. Specifically states "Not for sale to US"

That sounds like a lot more than the 32.4% whp gain claimed by Cusco for the intercooled version.

[Panman]

Originally Posted by Fast_Freddy

That sounds like a lot more than the 32.4% whp gain claimed by Cusco for the intercooled version.

eBay ad topline:
TESTED IN AUSTRALIA - 163KW AT REAR WHEEL
FACTORY POWER WAS 105KW AT WHEEL

105->163KW But,,,,,,, That's an eBay ad that also says "32.4%"

YHPMV