Scion gt86 owners 2013-2019 - Page 4 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Dadhawk · 01-29-2020, 09:41 AM

Quote:

Originally Posted by soundman98

if you think that's bad, try dailying a pickup truck.

20 gallons, even at regular cost goes pretty quickly at 5-9 mpg!

What pickup are you driving that gets 5-9 MPG? Or are you towing something huge?

Payload · 01-29-2020, 09:44 AM

I'm sure a lot of you guys already knew that.. I was explaining that to one particular person that asked me about what part of the engine is involved with compression.. Ultimately a car engine is a controlled thermodynamic open/closed system that sets off bombs or a.k.a "explosions" in a well timed fashion...

Payload · 01-29-2020, 09:44 AM

There are many mechanical instruments that make a car engine. The throttle body instrument is one of many components that make the car engine operable throughout the cars entire engine system set up. The throttle body is responsible for pulling in quantities of air that have to be compressed in order to enter the cylindrical bore and stroke chambers of that particular compartment of the engine.. Hence the throttle body plates rotate to compress air through a duct casting hole that is smaller in cross sectional area in comparison to the throttle body cross sectional area..

Payload · 01-29-2020, 09:51 AM

Wait, guys I'm trying to scam any of you.. I show you guys a link on how I estimated what my hp should be valued at. This is the manufacturers site of the fuel pump I purchased... It has a fuel injector calculator, it uses other parameters that you can plug in the tab spaces to estimate hp.. I'll post the link with this message, so you can overview it.. You can decide for yourself, as far as tunning we can discuss what I have done. I'll be willing to share it, at that point you can dyno my tunes and discuss your results, I my self would like to know how accurate these calculated valves are compared with a dyno. https://www.deatschwerks.com/fuel-ca...tor-calculator

Tomm · 01-29-2020, 09:59 AM

How many of you clicked that link?

NoHaveMSG · 01-29-2020, 11:19 AM

Quote:

Originally Posted by Tomm

How many of you clicked that link?

I didn’t bother because I already know what it is.

Let’s say you are building a turbo kit with a target of 400hp. This just helps you pick the correct injector for your estimated power level.

Spuds · 01-29-2020, 11:53 AM

NoHaveMSG · 01-29-2020, 01:02 PM

Quote:

Originally Posted by Payload

There are many mechanical instruments that make a car engine. The throttle body instrument is one of many components that make the car engine operable throughout the cars entire engine system set up. The throttle body is responsible for pulling in quantities of air that have to be compressed in order to enter the cylindrical bore and stroke chambers of that particular compartment of the engine.. Hence the throttle body plates rotate to compress air through a duct casting hole that is smaller in cross sectional area in comparison to the throttle body cross sectional area..

No. OMG I don't even know where to begin.

All compression ratio is, is the total volume of the combustion chamber + cylinder at bottom dead center. To the volume of the combustion chamber at top dead center. Has nothing to do with supercharging.

Quote:

Originally Posted by Payload

Wait, guys I'm trying to scam any of you.. I show you guys a link on how I estimated what my hp should be valued at. This is the manufacturers site of the fuel pump I purchased... It has a fuel injector calculator, it uses other parameters that you can plug in the tab spaces to estimate hp.. I'll post the link with this message, so you can overview it.. You can decide for yourself, as far as tunning we can discuss what I have done. I'll be willing to share it, at that point you can dyno my tunes and discuss your results, I my self would like to know how accurate these calculated valves are compared with a dyno. https://www.deatschwerks.com/fuel-ca...tor-calculator

All that tells you is how much HP the injector will support. Not what the engine can make

You do realize there is an entire section of the forum dedicated to tuning. From DYI to pros.

https://www.ft86club.com/forums/forumdisplay.php?f=88

korhun · 01-29-2020, 01:06 PM

This thread reminded me the Worst. Design. Ever.
I don't know why..

Spuds · 01-29-2020, 01:57 PM

Quote:

Originally Posted by NoHaveMSG

No. OMG I don't even know where to begin.

All compression ratio is, is the total volume of the combustion chamber + cylinder at bottom dead center. To the volume of the combustion chamber at top dead center. Has nothing to do with supercharging.

All that tells you is how much HP the injector will support. Not what the engine can make

You do realize there is an entire section of the forum dedicated to tuning. From DYI to pros.

https://www.ft86club.com/forums/forumdisplay.php?f=88

Noone can be that wrong without actually knowing they are wrong. It's like getting a 0 on the SATs. Hopefully it's just for fun and not actually trying to scam people. Or an experimental chatbot that was exposed to some Civic forums too early in life.

Awww why'd you have to point them towards serious discussions...

KR-S · 01-29-2020, 02:12 PM

Quote:

Originally Posted by korhun

This thread reminded me the Worst. Design. Ever.
I don't know why..

This reminds me more of when the infamous Mike Cina claimed he was making 221whp with his custom made parts...

This, however, is even better. Who knew I could make 300hp with just a fuel injectors and a tune?

NoHaveMSG · 01-29-2020, 02:18 PM

Quote:

Originally Posted by Spuds

Noone can be that wrong without actually knowing they are wrong. It's like getting a 0 on the SATs. Hopefully it's just for fun and not actually trying to scam people. Or an experimental chatbot that was exposed to some Civic forums too early in life.

Awww why'd you have to point them towards serious discussions...

I want to see how he responds to it.

"One of the great challenges in life is: knowing enough to think you're right, but not enough to know you're wrong."
- Neil deGrasse Tyson

KR-S · 01-29-2020, 02:25 PM

Quote:

Originally Posted by NoHaveMSG

I want to see how he responds to it.

"One of the great challenges in life is: knowing enough to think you're right, but not enough to know you're wrong."
- Neil deGrasse Tyson

Not that this thread has much value anyway, but why not have a mod move it to the correct section so that everybody can rip on it?

Lantanafrs2 · 01-29-2020, 04:19 PM

I'm using e85. I must be at 300bhp right now and not know it

01-29-2020, 09:59 AM	#47
Tomm Identifying as a Member Join Date: Aug 2018 Drives: 2013 FRS LS1 Location: HF, WV Posts: 243 Thanks: 115 Thanked 171 Times in 105 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	How many of you clicked that link? __________________ In the midst of an LS1/T56 swap build page here or follow me on YouTube or IG. ACT Clutches - APEXi - Buddy Club - Carbing - DBA - Diode Dynamics - Fidanza - HKS - ICT Performance - Project Kics - RPM Transmissions - SEIBON - Sikky Manufacturing - SPC - Tick Performance - TK Style - VERUS - VOLK - Whiteline

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
My Toyota GT86 Lapis Blue 2019	Alastor	FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum	8	03-06-2020 04:13 AM
Openflash Tablet for GT86 – Scion FRS, Subaru BRZ, Toyota 86 (2012 to 2019)	Redline360	Engine, Exhaust, Bolt-Ons	0	08-05-2019 10:28 PM
2018 vs 2019 gt86	krossfyah	Scion FR-S / Toyota 86 GT86 General Forum	8	02-21-2019 06:50 AM
WTB: 2013 Scion FR-S Owners Manual	Kicker18	Want-To-Buy Requests	2	01-10-2017 02:30 PM
Toyota GT86 / Scion FR-S Convertible Rumored for Geneva Debut in March 2013	Hachiroku	Scion FR-S / Toyota 86 GT86 General Forum	61	11-27-2012 08:50 AM

01-29-2020, 09:44 AM	#44
Payload Banned Join Date: Apr 2019 Drives: Raven black manual transmission Location: New York city Posts: 51 Thanks: 0 Thanked 3 Times in 3 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	I'm sure a lot of you guys already knew that.. I was explaining that to one particular person that asked me about what part of the engine is involved with compression.. Ultimately a car engine is a controlled thermodynamic open/closed system that sets off bombs or a.k.a "explosions" in a well timed fashion...

01-29-2020, 09:51 AM	#46
Payload Banned Join Date: Apr 2019 Drives: Raven black manual transmission Location: New York city Posts: 51 Thanks: 0 Thanked 3 Times in 3 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	Wait, guys I'm trying to scam any of you.. I show you guys a link on how I estimated what my hp should be valued at. This is the manufacturers site of the fuel pump I purchased... It has a fuel injector calculator, it uses other parameters that you can plug in the tab spaces to estimate hp.. I'll post the link with this message, so you can overview it.. You can decide for yourself, as far as tunning we can discuss what I have done. I'll be willing to share it, at that point you can dyno my tunes and discuss your results, I my self would like to know how accurate these calculated valves are compared with a dyno. https://www.deatschwerks.com/fuel-ca...tor-calculator

01-29-2020, 11:53 AM	#49
Spuds The Dictater Join Date: Apr 2017 Drives: '13 Red Scion FRS Location: MD, USA Posts: 9,637 Thanks: 26,669 Thanked 12,693 Times in 6,288 Posts Mentioned: 88 Post(s) Tagged: 0 Thread(s)

01-29-2020, 01:06 PM	#51
korhun Database error Join Date: Jun 2019 Drives: BRZ Location: Turkey Posts: 815 Thanks: 4,741 Thanked 1,672 Times in 619 Posts Mentioned: 15 Post(s) Tagged: 0 Thread(s)	This thread reminded me the Worst. Design. Ever. I don't know why..

01-29-2020, 04:19 PM	#56
Lantanafrs2 Senior Member Join Date: Jan 2018 Drives: 2013 frs red Location: South Florida Posts: 3,562 Thanks: 2,568 Thanked 3,126 Times in 1,680 Posts Mentioned: 6 Post(s) Tagged: 1 Thread(s)	I'm using e85. I must be at 300bhp right now and not know it

User Name		Remember Me?
Password