Have you had to replace any axles?

[DAEMANO]

Originally Posted by smg1138

What are your measurements at the pinch welds? I think my rear fenders are uneven, so that might give me a better idea where to set it.

Haven't measured it from the welds because that's generally less accurate (and also because it's hard to find perfectly level ground outside of a shop).

It's been a while since I've take a measurement from the center of the hub to the fender, but I suppose I could do that this weekend to see if the car has sagged at all. I'll do that and post here.

[smg1138]

Originally Posted by DAEMANO

Haven't measured it from the welds because that's generally less accurate (and also because it's hard to find perfectly level ground outside of a shop).

It's been a while since I've take a measurement from the center of the hub to the fender, but I suppose I could do that this weekend to see if the car has sagged at all. I'll do that and post here.

Were you able to get those measurements? Looks like my rear hub to fender measurement is 13.5" currently. I think that's about 1.25" lower than stock.

[DAEMANO]

Originally Posted by smg1138

Were you able to get those measurements? Looks like my rear hub to fender measurement is 13.5" currently. I think that's about 1.25" lower than stock.

Thanks for the reminder!

[smg1138]

Originally Posted by DAEMANO

Thanks for the reminder!

I'm currently at 13.25" in the rear hub to fender. Think that's in the safe zone?