FINISHED PRODUCT!

[Cole]

Originally Posted by Chase1996

So get front camber bolts? and set the camber to what on the front and back?

I'd recommend maxing the camber in the front. I'm running -2.5F and -2R. I like it, but YMMV. Do some research and see what others say. Then, decide where to go from there. Unless you want us to spoon feed you more. I'd be much obliged.

[Tcoat]

Originally Posted by humfrz

DANG, @Chase1996 ... you're bout to push ol @Tcoat over the edge ...... and he just returned from R&R ....

This is a good review:

http://www.ft86club.com/forums/showthread.php?t=25001


For your DD, I'd suggest you just ask the alignment shop to put the front and rear within spec ..... maybe the camber a little on the negative side of the range.


humfrz

Nah Hum no worries. As harsh as that may read it was intended more in jest than anything. Although it was of course also meant to make the point that the base info was already in front of him and he just needs to look a little further.