black buttons???? - Page 20 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Jive Turkey · 02-18-2013, 05:01 AM

Quote:

Originally Posted by Lee358

:0 im liking this idea

Sent from my iPhone using Tapatalk

i'll update this thread when i get something produced. feel free to give me any suggestions...etc.

Mrqb22 · 02-19-2013, 07:11 PM

Can anyone get a part number for the 86 climate control panel dual digital one ?

chanomatik · 02-20-2013, 08:57 PM

Quote:

Left hand driver radio Fascia Middle
# SU00301910
$ 21.17

Right Hand Side Piece Fascia
# SU00301932
$ 31.13

What are these two pieces referring to? I would like to replace the radio surround and the design that goes to the passenger area on the dash, if that's what those are referring to.

Also bump for updated pics! I'm hoping to order these pieces pretty soon here. Gonna order the red GT-86 to go with these parts.

abutterman · 02-20-2013, 11:32 PM

Quote:

Originally Posted by chanomatik

What are these two pieces referring to? I would like to replace the radio surround and the design that goes to the passenger area on the dash, if that's what those are referring to.

Also bump for updated pics! I'm hoping to order these pieces pretty soon here. Gonna order the red GT-86 to go with these parts.

Those are the correct parts for the radio/dash trim. I have a picture of them installed a page or so back

chanomatik · 02-21-2013, 12:50 PM

Quote:

Originally Posted by abutterman

Those are the correct parts for the radio/dash trim. I have a picture of them installed a page or so back

I see your picture show left and right center console pieces that surround the knobs and stop just underneath the radio. I was seeing if there were replacement for the radio surround and passenger side design. Even in your pic it's still the stock "T"/"Space Invaders" design. In the BRZ they're silver.

Also, is the "knee attachment" that leather pad with the red stitching? No way that costs that little if that is it!

Edit: Nevermind! It's a few posts down. I meant to ask you if that's what that was because the camera makes it look like it could be silver, for some reason. Thanks! I feel derpy. haha Contrasting with your paddle shifters, they're definitely matte black.

abutterman · 02-21-2013, 01:06 PM

lol yea i replaced all the silver trim and the space invaders with the matte black parts. The knee pads with the red stitching i got from @nigel-jdmparts. Those were a bit more expensive but make it look much better.

chanomatik · 02-21-2013, 01:09 PM

Yeah, I just ordered those, too. Should be here any day now, along with the speaker surround. I guess I'm wondering what the "knee attachments" are then?

abutterman · 02-21-2013, 01:46 PM

Quote:

Originally Posted by Fizz

FYI, just received email from derek @ villagetoyota saying that they're unable to post items internationally anymore. I guess i'll need to look into registering with a freight forwarding company.

Amayama will ship internationally but they need a VIN number. Which I don't because my car hasn't been delivered yet. Would someone be kind enough to PM me a VIN number for either an FR-S or the Australian GTS model?

They don't actually verify the vin. You can just put whatever there or pull one off a dealers inventory site. I put my vin and gt2000 as the model. They dont seem to care what you put. I think it's more so if you're asking for a part number that you're unsure of.

RazBRZ · 02-21-2013, 03:25 PM

I just ordered the black switches from Amayama.
No VIN needed. I put for the info.
Year - 2013
Make - Toyota
Car - Scion
Vin - FR-S
They e-mailed my with the instuctions for purchase, price, and shipping info. No questions asked.
I'm going to paint the rest of the parts, my dash inserts came out great. It was the first mod I made after I bought it. I don't know why I waited so long to order the switches.

I have a question though. How hard and how do you get the piece off of the steering wheel?

chanomatik · 02-21-2013, 08:40 PM

Quote:

Originally Posted by RazBRZ

I have a question though. How hard and how do you get the piece off of the steering wheel?

Your answer below.

Quote:

Originally Posted by Sutty

You'll kick yourself about removing the airbag - seriously if you can hold a screwdriver you can remove it safely.
I've done it a good few times whilst I was vinyl wrapping that piece of trim. I didn't even bother disconnecting the battery.
I sure it's been mentioned but it's only a case of pushing on three spring clips at 3,6 & 9 o'clock behind the airbag, it springs off, undo two Phillips head screws, remove piece.
Replacing is reversal of the above.

RazBRZ · 02-21-2013, 09:34 PM

As long as it doesn't go off on me. That's how my luck usually goes

Sutty · 02-22-2013, 01:47 AM

Quote:

Originally Posted by RazBRZ

As long as it doesn't go off on me. That's how my luck usually goes

I just did it again at the weekend as I sent my pieces off for CF skinning, airbag didn't deploy again.
What you must remember is that the airbag is designed to deploy when you car is in motion and involved in a frontal impact. Now that doesn't discount a malfunction or electrical short setting it off, but it's not the big bad scary monster that most people think it is. If your car is stationary, the ignition is off and you don't start shorting out wires your chance of setting it off is minimal. If you are too scared though, remove the negative terminal off the battery, flash your high beams a couple of times to ensure any residual energy is depleted from the electrical system and then remove it.

Iddoit2er · 02-23-2013, 04:54 PM

abutterman · 02-23-2013, 05:34 PM

Quote:

Originally Posted by Iddoit2er

what are the switches for in the middle? heaters or lights or something?

02-19-2013, 07:11 PM	#268
Mrqb22 Senior Member Join Date: Sep 2012 Drives: 2013 FR-S Whiteout Location: Cleveland Ohio Posts: 264 Thanks: 12 Thanked 28 Times in 22 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Can anyone get a part number for the 86 climate control panel dual digital one ? __________________ 2013 Whiteout 2013 XB black pearl.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
are all control buttons illuminated?	ron wright	BRZ First-Gen (2012+) — General Topics	14	10-27-2015 09:44 PM
XXR527 Chromium black 18x8.75 Hankook Ventus 225-40 Black BRZ	random hero	Wheels \| Tires \| Spacers \| Hub -- Sponsored by The Tire Rack	66	02-14-2013 01:20 AM
Oakley Halfjacket 2.0 Polished Black with Black Iridium lenses.	Zadkiel	Miscellaneous	8	12-02-2012 02:51 PM
Rear Seat Release Buttons	NedVargar	Issues \| Warranty \| Recalls / TSB	7	08-29-2012 02:43 PM
do you want steering wheel buttons?	Spaceywilly	BRZ First-Gen (2012+) — General Topics	125	04-09-2012 09:46 AM

02-21-2013, 01:06 PM	#272
abutterman Senior Member Join Date: Dec 2012 Drives: 2013 BRZ Limited - WRB, MT Location: Long Island, NY Posts: 1,177 Thanks: 58 Thanked 176 Times in 139 Posts Mentioned: 15 Post(s) Tagged: 0 Thread(s)	lol yea i replaced all the silver trim and the space invaders with the matte black parts. The knee pads with the red stitching i got from @nigel-jdmparts. Those were a bit more expensive but make it look much better.

02-21-2013, 01:09 PM	#273
chanomatik Snow Don't Hurt! Join Date: Jul 2012 Drives: 2013 BRZ Limited 6MT CBS Location: Anchorage, Alaska, USA Posts: 2,538 Thanks: 6,416 Thanked 1,497 Times in 902 Posts Mentioned: 42 Post(s) Tagged: 0 Thread(s)	Yeah, I just ordered those, too. Should be here any day now, along with the speaker surround. I guess I'm wondering what the "knee attachments" are then?

02-23-2013, 04:54 PM	#279
Iddoit2er Senior Member Join Date: Dec 2012 Drives: S Location: a Posts: 137 Thanks: 4 Thanked 20 Times in 18 Posts Mentioned: 4 Post(s) Tagged: 0 Thread(s)

User Name		Remember Me?
Password