07-26-2019, 09:03 PM | #1 |
Junior Member
Join Date: Apr 2013
Drives: WRB Subaru BRZ
Location: San Francisco, CA
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
2013 WRB Subaru BRZ, Turbo/TE37/Brembos
I'm listing my 2013 Subaru BRZ Limited for sale for $19,000.
I am currently in the San Francisco Bay Area with the car but I might be willing to meet someone in a neighboring state if I need to. I have been the only owner since I drove it off the lot with 16 miles on the odometer (most of which was from my test drive). The odometer is now just under 37,000 miles. I have done most of the installs and maintenance myself. Here is a list of parts that I can remember that are installed on the car. There may be other small things I can't remember right now: Engine/Exhaust: -P&L Turbo Kit -Precision Ball bearing Turbo has been rebuilt and hot side ceramic coated -P&L Headers have been ceramic coated -JDL 3 in Down/Front Pipe, Perrin 3 in catback exhaust. It was the quietest and most tame setup I could run at the time while keeping it unrestricted 3 in all the way through the exhaust. Deep and mean sounding, but not obnoxious. -Street tuned to around 10.5 psi by James at HRI Tuning -Full Blown Motorsports oil cooler -ECUTEK with racerom kit and cable and -ECUTEK bluetooth connect dongle (allows me to monitor engine parameters/change maps and boost levels on my phone) Crawford Racing air/oil separator -Grimspeed boost solenoid Transmission: -Clutch Masters FX400 clutch and flywheel -Kartboy short throw shifter -Every whiteline/perrin transmission bushing there is -Flossy shorty heavy weight shift knob -Transmission/diff fluid changed at 20k miles Wheels/Brakes: -18x9.5 Rays TE37SL. I have the stickers but I never installed them -Michelin Pilot Super Sport 18x265 on all 4 corners -STI Brembo swap, rebuilt and powdercoated brakes white (I know thats a terrible color for brakes but shes a garage queen) -DBA slotted rotors -Project Mu NS400 brake pads -Stainless braided brake lines -ARP wheel studs on the rear wheels -Perrin brake booster brace Suspension: -MCS one-way adjustable coilovers -400# springs front and rear -HVT adjustable camber front top hats -SPC adjustable rear lower control arms Miscellaneous/Cosmetic: -Toms smoked taillights -Trackspec hood vents (these with the oil cooler have really stabled out the under hood temps. Before I was in California I lived in FL. I could do multiple back to back pulls in 90F+ heat no problem with this cooling setup) -Perrin Shorty antenna -Front and rear backup cameras (the rear has a loose wire so its not working right now) -Grimspeed hood struts -clear side markers -white tow hook The bad news, even though I am in California, the car is registered in Florida. I don't know anything about CARB laws but I have a feeling the P&L turbo is not CARB legal if your trying to register it in California. Sorry. It could use a good four corner alignment too. It was aligned by an okay shop when I put the wheels and tires on but they weren't a specialized race shop and I think I've adjusted the height of the coilovers a little since then. I've done my best to take care of this car over the years. Its always been garaged. I detail her often. Every part I've installed I made sure was top of the line and quality. Fluids and filters where changed religiously with quality oils. I have never had any problems with the car. She runs like a champ and is a blast to drive. I've moved on to other projects so I think its time to let her go. Let me know if you have any questions or anything. Again, asking $19,000. Last edited by JW-BRZ; 09-23-2019 at 04:08 AM. |
08-06-2019, 09:34 PM | #2 |
Member
Join Date: Apr 2016
Drives: Monogram FRS
Location: Santa Cruz, CA
Posts: 68
Thanks: 1
Thanked 2 Times in 2 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
PM'd
|
09-23-2019, 04:09 AM | #3 |
Junior Member
Join Date: Apr 2013
Drives: WRB Subaru BRZ
Location: San Francisco, CA
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Priced drop to $19,000. Looking for someone to take it as is. Otherwise, I'll be parting out when I get a chance in the next few months.
|
|
|
Tags |
brembo, brz, te37sl, turbo |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My 2013 Subaru BRZ Turbo build | Suparu | Member's Car Journals | 38 | 07-08-2020 06:25 PM |
Subaru BRZ 2013 WORKS Stage 2 Turbo | hough927 | Cars for Sale/Trade | 0 | 04-21-2018 02:06 AM |
2013 Subaru BRZ Limited - Turbo - $19000 | Illuminaughty | Cars for Sale/Trade | 6 | 05-04-2017 10:28 PM |
2013 Subaru BRZ Limited Turbo for Sale | Out_Run86 | Cars for Sale/Trade | 17 | 04-20-2017 02:23 PM |