MAP sensor bolt spec - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Ignore Your Doctor · 03-13-2023, 11:07 AM

A few years ago I swapped my 2015 plastic intake manifold with the wrinkle red one from 2017+ and reused the original bolt. It wasnt an exact fit but kept the map sensor in place so I didnt fret over it. Now I am upgraded to a 4 bar and upping my boost so I want to get the correct bolt. See below for clarification

im sure I can pick something up at the hardware store just cant find measurements anywhere online

Ohio Enthusiast · 03-13-2023, 12:38 PM

My 2018 appears to use a coarse M5x15 flanged bolt with an un-threaded shoulder about 2.5 mm long at the base and an 8mm head. It doesn't look like the shoulder part is critical - it is narrower than the threads (vs. more typical shoulders where they are in the outer diameter of the thread) so couldn't be used for locating the bolt on the sensor.

03-13-2023, 11:07 AM	#1
Ignore Your Doctor Senior Member Join Date: Oct 2015 Drives: 2015 BRZ WRB Location: Atlanta, GA Posts: 171 Thanks: 7 Thanked 25 Times in 19 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	MAP sensor bolt spec A few years ago I swapped my 2015 plastic intake manifold with the wrinkle red one from 2017+ and reused the original bolt. It wasnt an exact fit but kept the map sensor in place so I didnt fret over it. Now I am upgraded to a 4 bar and upping my boost so I want to get the correct bolt. See below for clarification im sure I can pick something up at the hardware store just cant find measurements anywhere online

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OEM 14mm crash bolt torque spec?	SmoothIsSlow	Suspension \| Chassis \| Brakes -- Sponsored by 949 Racing	4	07-09-2019 11:20 AM
Perrin/Mocal oil cooler - Torque spec for center bolt	Clipdat	Engine, Exhaust, Transmission	12	01-08-2019 01:57 PM
Crankshaft position sensor bolt size	sfruski	Engine, Exhaust, Transmission	0	09-01-2017 11:10 PM
Rear link bolt spec needed	Mikepage	Suspension \| Chassis \| Brakes -- Sponsored by 949 Racing	4	02-08-2015 10:21 PM
Camber bolt torque spec	ayau	Suspension \| Chassis \| Brakes -- Sponsored by 949 Racing	3	01-09-2013 10:30 AM

03-13-2023, 12:38 PM	#2
Ohio Enthusiast Senior Member Join Date: Apr 2020 Drives: 2018 BRZ Location: Dayton, OH Posts: 931 Thanks: 1,390 Thanked 784 Times in 446 Posts Mentioned: 12 Post(s) Tagged: 0 Thread(s)	My 2018 appears to use a coarse M5x15 flanged bolt with an un-threaded shoulder about 2.5 mm long at the base and an 8mm head. It doesn't look like the shoulder part is critical - it is narrower than the threads (vs. more typical shoulders where they are in the outer diameter of the thread) so couldn't be used for locating the bolt on the sensor.

User Name		Remember Me?
Password