Thread
:
Irace86.2.0 Build
View Single Post
08-03-2020, 09:22 PM
#
158
Irace86.2.0
Senior Member
Join Date: Mar 2017
Drives: Q5 + BRZ + M796
Location: Santa Rosa, CA
Posts: 7,882
Thanks: 5,665
Thanked 5,802 Times in 3,297 Posts
Mentioned: 70 Post(s)
Tagged: 0 Thread(s)
Here is the problem: I wanted the large tire in the rear look, and I wanted a deeper concave rim in the rear than the front, which means a different offset. There was limited sizes, so in the end the rear had slight poke and the front had slight tuck. If I would have gone square then I would have had large poke in the front.
Rear poke:
Front tuck:
Here is the fix:
The fronts were pretty straight forward. The rears required the parking brakes and the hub to be removed, so they each took an extra 10-15 minutes, but they weren't bad at all:
Poke is now equal (and minor). If I do some camber sometime in the future then they will be perfectly flush or tucked.
__________________
My Build
|
K24 Turbo Swap
| *K24T BRZ SOLD*
The Following User Says Thank You to Irace86.2.0 For This Useful Post:
Ash_89
(05-02-2021)
Irace86.2.0
View Public Profile
Send a private message to Irace86.2.0
Find More Posts by Irace86.2.0