I received the replacement plastic sun visor mounts from Craftcloud but I ran into a problem. I removed the sun visor to feed the wire through the hole of the new plastic mount. The wire is for the illumination but the connector is too big and won't fit through the hole. So I need to depin the wires from the connector and run the wires through, then repin them.
But even with a jeweler's flathead I can't seem to get the tiny plastic clip that holds these wires into the connector.
Any ideas aside from forking over $100 to Subaru? I've already come this far :\
Here's the connector that's too big to feed through the hole:
Here's a shot of what I'm trying to depin:
Quote:
Originally Posted by JimR
Just a bump: I tried the Thingverse 3D print linked above for the visor mount. They have a "Craftcloud" printing service that selects the cheapest vendor for what you want.
|
@
JimR how did you get these wires depinned?