Quote:
Originally Posted by Gopherboy6956
Hey Guys - I have a AEM Digital Wideband A/F (30-4110) installed, and had it hooked up to my previous P&L Header (had 3 A/F bungs)
I switched to the Open Flash UEL header, and didn't even think to remember to add a 3rd Bung.
What's the best process to have this stuff hooked up?
Is it:
1. Just take the header off and add a bung?
2. Remove one of the stock 02's and the tune can 'turn it off' ?
3. Play around with wiring and have all 3 signals coming from two 02s?
Any help is appreciated.
Thank you!
|
rearly easy option is to just rescale the stock front 02 sensor to read more wideband, it will read doen to about 10 afr which is good for NA and even some boosted setups
http://www.ft86club.com/forums/showp...6&postcount=40
dont remove or alter the front o2 sensor its the primary fueling sensor.
if you want to add the wideband best to add the third bung and wire it in completly independantly.
you could use the rear 02 sensor port and disable a few cel codes in tune and disable the AF#3 correction.
Ot mabe remove the frontpipe and put in the third bung at the start of that some frontpipes i have seen have a third bung installed their.before cat