01-15-2021, 02:25 AM
|
#74696
|
|
Senior Member
Join Date: Jul 2013
Drives: '17 Limited BRZ CWP w/ PP
Location: San Jose, CA
Posts: 5,774
Thanks: 14,056
Thanked 6,471 Times in 3,207 Posts
Mentioned: 68 Post(s)
Tagged: 0 Thread(s)
|
Ahhh, dang. I doubt I can do it. With my hand tremors I don't think I should trust myself to keep the globe steady enough while my 2nd hand is dealing with the screws. Welp. 
Quote:
Originally Posted by NoHaveMSG
Those 4 screws sit in a groove in the globe. Just back them out with one hand while supporting the globe with the other, install is reverse of removal.
|
Quote:
Originally Posted by humfrz
I figure those 4 screws hold the glass globe in place. Just unscrew them a little at a time, while holding the glass globe in place, until the globe drops down.
Replace the burnt out bulb(s), put the globe back in place and carefully, barely snug, then back off each 1/4 turn the 4 screws up till they gently hold the globe in place.
DO NOT put larger bulbs that were in there, in place.
DO NOT try it while the globe is hot.
DO NOT perform the operation while drunk.
DO USE a step stool or step ladder NOT a kitchen chair to stand on.
 |
__________________
Instagram: @ spike.brz
Quote:
Originally Posted by humfrz
It sounds to me like the delicate, metallic sounds of piston skirts slapping against the cylinder walls
|
Quote:
Originally Posted by Tcoat
Now, if it was three feet long and you were using all that leverage
|
|
|
|