Quote:
Originally Posted by Tcoat
You are looking for 12 volts from the harness. If it is there you at least have base power going to the ballasts.
|
Quote:
Originally Posted by Grady
So you have voltage at the headlight connectors?.
|
Ok folks, I got a voltage read from the connectors driver/passenger side, measure in
20V to Ground, on the screws near the strut. These were tested on Accessory mode and I even turned the headlight switch on.
If I'm not mistaken, the wires to both headlights is the slightly thicker ones out of all the ones that go up to the connector right? If so,
Passenger Side (RED) wire reads: 12.35v
Driver Side (Light BLUE) wire reads: 12.30v
As far as I understand it, I will be buying bulbs and hopefully not ballasts!
EDIT: I will be inspecting the ballast tomorrow to see any signs of water damage or frying. If I do not see any signs, I will go through the "trial by error" method of buying a bulb.