Quote:
Originally Posted by xkalelx
I was going to ask about that as well. That doesn't seem right. The only reason you would have to do that is if you have interference issues with the piston and wrist pin. No one else has ever mentioned doing that before going when going to upgraded rods and pistons so I am going to disregard that modification.
EDIT: Looks like he was having interference with that rod selection and stock pistons. For the cost and trouble, I will just be replacing with new pistons when I get to that point.
|
i ended up going with a different set of rods than the skunk H beams, but still a little alarming. ive had enough problems with this machine shop being slow and dont need another delay haha.