Quote:
Originally Posted by 02maher
The heating system doesn’t have an ecu… are you sure you’re getting U0164?
You had a fire in the engine bay so you changed the wires, did you also have a look at the hoses for leaks? What about the air intake it’s in plastic so a fire could have damaged it easily! Without proper DTC it would be hard to find the problem but if you can maybe record the air fuel ratio and fuel trims once you start the car until it stalls it could help pinpoint the issue.
|
I have done a log run a few weeks ago this are the results(in the .txt below). The fire was near the battery and I extinguished it in a min. The hoses are ok or new. The air intake is an aftermarket and is also good. Yesterday I worked on the car and used a other code reader. (From a Mechanic shop) the I saw that the ECM, transmission ecu and the cluster got the fault code U0140 so I checked the wires and they were good. Now I am searching a used Body ECU.
https://www.ft86club.com/forums/atta...8&d=1649620578
(The txt is an attachment in a other Thread)