View Single Post
Old 03-20-2024, 01:56 PM   #19875
cmiovino
Senior Member
 
cmiovino's Avatar
 
Join Date: Aug 2020
Drives: 2017 BRZ PP, 2004 WRX
Location: Pittsburgh
Posts: 350
Thanks: 16
Thanked 256 Times in 159 Posts
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Quote:
Originally Posted by Breezio View Post
Put her back down on the ground after being on jack stands all winter. Gave her a bath and headed to the first autocross (for me) of the season.
What's your ride height looking for autox?

I've been running DS for 4 years and actually never owned adjustable coilovers only any of the cars I've run.

My front is set at about 5 1/2 inches at the pinch welds, which allows me to just squeeze my low profile jack under the front in the middle.

Rear I was playing with since the rear driver's side needed to be raised a good bit to get even with the other side. I'm now sitting at about 6" at the pinch welds in the rear, which more or less makes the rear wheel gap look close to stock.

Not sure if the height is going to affect handling much. Still need to get around town (at least to events) and PA has a much of potholes and hills.
__________________
2017 BRZ Limited Performance Pack - Steel Cities Region SCCA / North Hills Sports Car Club
cmiovino is offline   Reply With Quote
The Following User Says Thank You to cmiovino For This Useful Post:
Breezio (03-21-2024)