|
Very nice. What are you using for a controller? These days Arduino, Beagle Board or Raspberry Pi make sense if you can get them configured for the task. Gotta get some programming done, a whole other learning set.
I was looking into controller boards for custom pinball machines but electronics is completely self taught for me and the task of creating the programming was daunting. Incidently most of my pinball machines were used to raise funds for the FRS.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
|