Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - CAN BUS - for DIY swappers, HELP! Engineers / shops welcome

Kurt Sampson · 01-12-2021, 12:35 AM

I have a 86, engine swapped a 3SGE Beams with a EMU Black. as far as i can tell everything works on my car like traction control ect. however after I completed the swap my fuel gauge does not register if I put some fuel in the car it would show me the correct fuel level and after driving for a while the needle would stay on one place, i would disconnect the battery and after 30 seconds reconnect the battery in order to see the current fuel level. this is the processes after every trip. is this related to the EMU not supporting fuel economy readout (1/100km)?

01-12-2021, 12:35 AM	#131
Kurt Sampson Member Join Date: Mar 2019 Drives: Toyota GT86 Location: Western Cape Posts: 10 Thanks: 0 Thanked 1 Time in 1 Post Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I have a 86, engine swapped a 3SGE Beams with a EMU Black. as far as i can tell everything works on my car like traction control ect. however after I completed the swap my fuel gauge does not register if I put some fuel in the car it would show me the correct fuel level and after driving for a while the needle would stay on one place, i would disconnect the battery and after 30 seconds reconnect the battery in order to see the current fuel level. this is the processes after every trip. is this related to the EMU not supporting fuel economy readout (1/100km)? Last edited by Kurt Sampson; 01-12-2021 at 12:52 AM.