@
ThatYeti
Alright, as I compare your tape measure pictures to mine at just about the same angle that you snapped your pictures,
it would appear as if I need to begin grinding out the forward stud hole towards the passenger side a little bit to result in about a half inch of movement from the forward "point" of the risor base in the direction of the trunk lid edge.
The rearward stud hole looks to be in the perfect position.
Here are the measurements that I took with my dial caliper,
I measure 2-19/64" from the forward "point" of the risor base to the edge of the trunk lid at a right angle,
and 55/64" from the rear "corner" of the risor base to the edge of the trunk lid right where the downward slope begins.
If you or anyone else can take the same measurements that I did using a dial caliper and post those measurements, I would really appreciate it.
Thanks for helping me get this far.