Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - FS: SOLD SOLD Sprintex 210 Stage 2 Supercharger-Finally have a fast car! SOLD SOLD

continuecrushing · 02-10-2017, 04:25 AM

THIS KIT HAS SOLD!

The time has come for me to sell the Sprintex Stage 2 supercharger! Everything works great, but I'm now running the 335 kit instead.
This this is FUN, and an absolute blast to drive. See dyno video/drive by on bottom

Lets start with what you will need:
1. ECUTEK. You'll need a tune to run this kit. The top tuners for this are Delicious and Moto East. I have personally used both and had a great experience. You may want to look at a flex fuel kit, you'll make more power and the car will run better. If you're local, you might be able to borrow my cable-if I like you.
2. OEM coolant-this supercharger uses an air to water intercooler, and requires oem coolant. Dealer or amazon: http://amzn.to/2kaGO0G
3. Time to install. It will take 6-12 hours depending on your experience (and number of beer breaks)
4. 75W-90 gear oil, down the road. I will put fresh fluid in the supercharger, but it is recommended you check the level/flush it occasionally: http://amzn.to/2kb35vp

The ONLY thing missing is the bracket for the automatic wire harness. This only will be a minor issue if you have an automatic car. However, it's just a relocation bracket and you will be able to install this kit without it, and work just fine. Just mentioning it though. Also, its possible a few of the original screws have been misplaced, and I don't know exactly what size they are, but you or your installer should have replacements, as they aren't proprietary to the kit or anything. Wish I could help out more, but they are the kind of thing that you'll have to identify when installing. O-Ring for throttle body is not included either, I used RTV sealant last time.

Important stuff:
-This kit is AWESOME. When I first installed and went for a test drive, my immediate thought was, "why the hell didn't I do this earlier..."
-Not shown in photos but included are brass fittings for the rear of the supercharger. Stock they are plastic, and known to leak. This fixes that problem
-Power, I made 283whp and 220wtq. The car is pretty dang quick. See video
-Whine. This supercharger is a twin screw and it whines more than your gf. Seriously though, it sounds freaking awesome See video
-CARB EO NUMBER. This is HUGE. It does have a CARB sticker. Don't get a ticket because of this thing. Speeding, maybe lol. But they can't get you for the supercharger.
-The heat exchanger/front mount part is BRAND NEW. I just ordered this from Sprintex, just for you. Brand spanking new and it cost me $450
-I used this kit on stock engine/trans/clutch. YMMV, but other than a clutch (now or down the line) you should be good
-About 20k on this kit, with regular fluid changes

What is included:
-Sprintex stage 2 supercharger kit with 69mm pulley (giggity) and CARB Sticker
-2 belts
-brass fittings for rear of supercharger
-a bunch of hoses, clamps, brackets
-I'm also buying/providing 6ish feet of various hoses and adapters that you can use during install. I'm fairly certain all of the hoses are here, but it never hurts to have extra in case you damage/tear something during install.
-Color print out of install guide/manual

I would prefer to sell it to someone in person locally, but I *may* ship it if I cannot find a local buyer. Shipping is probably around $120, since this thing is heavy, but PM and we can figure something out.

Price is $2650 OBO. I will give preference to cash buyers.

PM with any questions!

[ame="https://www.youtube.com/watch?v=6PrOSM0ZpcA"]FRS Innovate Sprintex Supercharger Whine Drive By - YouTube[/ame]

[ame="https://www.youtube.com/watch?v=pd2pmz0Yg3c"]Supercharged FRS Dyno Pull at Mod Auto & ModBargains - YouTube[/ame]

SOLD SOLD SOLD

02-10-2017, 04:25 AM	#1
continuecrushing Join Date: Mar 2013 Drives: 2013 Firestorm FRS Location: Lake Elsinore, CA Posts: 2,707 Thanks: 1,231 Thanked 2,144 Times in 1,003 Posts Mentioned: 73 Post(s) Tagged: 2 Thread(s)	FS: SOLD SOLD Sprintex 210 Stage 2 Supercharger-Finally have a fast car! SOLD SOLD THIS KIT HAS SOLD! The time has come for me to sell the Sprintex Stage 2 supercharger! Everything works great, but I'm now running the 335 kit instead. This this is FUN, and an absolute blast to drive. See dyno video/drive by on bottom Lets start with what you will need: 1. ECUTEK. You'll need a tune to run this kit. The top tuners for this are Delicious and Moto East. I have personally used both and had a great experience. You may want to look at a flex fuel kit, you'll make more power and the car will run better. If you're local, you might be able to borrow my cable-if I like you. 2. OEM coolant-this supercharger uses an air to water intercooler, and requires oem coolant. Dealer or amazon: http://amzn.to/2kaGO0G 3. Time to install. It will take 6-12 hours depending on your experience (and number of beer breaks) 4. 75W-90 gear oil, down the road. I will put fresh fluid in the supercharger, but it is recommended you check the level/flush it occasionally: http://amzn.to/2kb35vp The ONLY thing missing is the bracket for the automatic wire harness. This only will be a minor issue if you have an automatic car. However, it's just a relocation bracket and you will be able to install this kit without it, and work just fine. Just mentioning it though. Also, its possible a few of the original screws have been misplaced, and I don't know exactly what size they are, but you or your installer should have replacements, as they aren't proprietary to the kit or anything. Wish I could help out more, but they are the kind of thing that you'll have to identify when installing. O-Ring for throttle body is not included either, I used RTV sealant last time. Important stuff: -This kit is AWESOME. When I first installed and went for a test drive, my immediate thought was, "why the hell didn't I do this earlier..." -Not shown in photos but included are brass fittings for the rear of the supercharger. Stock they are plastic, and known to leak. This fixes that problem -Power, I made 283whp and 220wtq. The car is pretty dang quick. See video -Whine. This supercharger is a twin screw and it whines more than your gf. Seriously though, it sounds freaking awesome See video -CARB EO NUMBER. This is HUGE. It does have a CARB sticker. Don't get a ticket because of this thing. Speeding, maybe lol. But they can't get you for the supercharger. -The heat exchanger/front mount part is BRAND NEW. I just ordered this from Sprintex, just for you. Brand spanking new and it cost me $450 -I used this kit on stock engine/trans/clutch. YMMV, but other than a clutch (now or down the line) you should be good -About 20k on this kit, with regular fluid changes What is included: -Sprintex stage 2 supercharger kit with 69mm pulley (giggity) and CARB Sticker -2 belts -brass fittings for rear of supercharger -a bunch of hoses, clamps, brackets -I'm also buying/providing 6ish feet of various hoses and adapters that you can use during install. I'm fairly certain all of the hoses are here, but it never hurts to have extra in case you damage/tear something during install. -Color print out of install guide/manual I would prefer to sell it to someone in person locally, but I may ship it if I cannot find a local buyer. Shipping is probably around $120, since this thing is heavy, but PM and we can figure something out. Price is $2650 OBO. I will give preference to cash buyers. PM with any questions! [ame="https://www.youtube.com/watch?v=6PrOSM0ZpcA"]FRS Innovate Sprintex Supercharger Whine Drive By - YouTube[/ame] [ame="https://www.youtube.com/watch?v=pd2pmz0Yg3c"]Supercharged FRS Dyno Pull at Mod Auto & ModBargains - YouTube[/ame] SOLD SOLD SOLD Last edited by continuecrushing; 02-19-2017 at 12:47 PM.