View Single Post
Old 05-27-2019, 06:29 AM   #4
bmacfrs
Senior Member
 
bmacfrs's Avatar
 
Join Date: Dec 2016
Drives: 2013 FRS
Location: Central PA
Posts: 274
Thanks: 132
Thanked 64 Times in 41 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
I had a similar problem. My entire exhaust is aftermarket so hanger points dont exactly match up. The effect was the connection for the borla muffler to the center pipe was getting pushed to the left side and making the mufflers edge too close to the car body. I fixed by fabbing a replacement bracket for the center pipe where it attaches to the trans so it would pull the pipes over a little. Just used some aluminum stock from local hardware store. Some appropriate bends and holes. Get everything in place and tighten. So far so good.


Sent from my SM-G960U using Tapatalk
__________________
WIFE: "How can there be anything left to buy?"
bmacfrs is offline   Reply With Quote