01-12-2023, 08:22 AM
|
#6
|
|
Be Kind
Join Date: Apr 2020
Drives: 2020 86
Location: MD
Posts: 1,078
Thanks: 5,162
Thanked 1,254 Times in 605 Posts
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Originally Posted by Ace23_BRZ
Agreed! This company did a great job with this build.
Hopefully, I too can inspire others with my individual build once she is revealed.
I will say though, I think I might be going a little too overboard with my wiring...I am not only doing a complete wire tuck on the exterior of the vehicle, but I am doing a nice and neat tuck in the cabin as well, including a full concentric twisted harness throughout the entire cabin as well.
Below is the start of my new interior harness, haha, and for those of you that have been following my build, "Yes," I am redoing my harness again...as I stated, if I don't feel like it's my best effort(s), I tear it apart and start over.
Haha, I think this is the one! It's just very time-consuming and requires a lot of preparation and zero room for error once complete.
Shit, wish me luck! LoL
|
Good luck! I'll be doing the same for my new-to-me bike and upgrading the wiring gauge at the same time to help with known issues.
|
|
|