Quote:
Originally Posted by beltax90
loved watching justins vids back when he had a brz! really helpful stuff especially his wheels and exhaust videos!
|
Definitely helpful, and it seems he and I have very similar taste in mods.
One note RE: installing the front lip - rather than stepping up in drill bit sizes, I used a 3/8" brad point drill bit (a woodworking bit, that has a sharp point in the centre to keep it from wandering and sharp outer edges to score a clean hole edge) and just drilled each hole once. When I use those type of bits, I always start the hole with drill running in reverse to score the surface/hole edges first, then run it forwards to finish the hole. Worked great on the nice, soft bumper material, but those bits are no good for metal, just an FYI...
Also, when installing the rear splash guards, my car didn't have the holes in the bumper edge pre-drilled, but they were very clearly marked, so easily done.