Quote:
Originally Posted by GrimmSpeed
We'd love to design a 'baller' bar, and perhaps sometime in the future we will, but for now, we're looking for maximum performance without a high-end cost. For that reason, the bar will likely be welded steel construction, similar to what's been shown so far.
Matt
Engineering
|
If it's steel I doubt I will buy one. Aluminium alloy will achieve the same rigidity for less additional weight and that factor is critical on this car.
The brackets for the struts could have been alloy too. Bolting steel onto the alloy bonnet was the only negative to that kit and I would happily pay the extra cost.