Quote:
Originally Posted by OICU812
Was it in instructions or you felt necessary to unload the struts per say?
|
I had heard that was a good thing to do.
I'm not quite sure what the instructions say (google translate version below)
"Installation of 1. Tower bar bracket
(1) As shown Figure 1, the suspension upper support
Remove the front side mounting nut, Burake of components ②
Install the Tsu Prefecture, and temporarily stopped.
(2) As Figure 2, RH front rod performance
* Remove the two front side mounting nut 2, the components ③
Install the bracket, and temporarily stopped.
LH side to carry out installation work (3) 1,,,, 2 (3) above. . . .
Bracket between two attached to both left and right as in (1) Fig 3
TRD logo is toward the front tower bar components to ①
The sandwich to be a tree.
Put from the rear side of the cap bolt (2) Components ⑥, components
* I temporarily fixed in the flange nut ⑦.
Mounting of 2. Tower bar
Tightening of work 3. Mounting bolts
Specify the port of each nut RH side LH side in the order shown in (1) Figure 4
I Tighten the torque.
① 23Nm ② 23Nm ③ 16Nm
(3) side also performed in the same manner (3) LH. . . .
①
②
③
Figure 4 the front of the vehicle
Tightening to lift down by installing the tire, suspension
State normal load is applied to the Pension
Please execute Te."